FVM and XCT Measurement of Surface Texture of Additively Manufactured Parts
Open Access
- 2 September 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
Focus variation microscopy (FVM) and X-ray computed tomography (XCT) are two popular technologies employed to measure the surface texture of additively manufactured components. The impacts of various influence factors of these two measurement techniques on surface texture measurement are investigated, respectively. A two-stage surface registration program is developed to allow the accurate comparison of surface topographies measured by two instruments at the same location on the surface. The associated surface texture parameters Sa, Sq, Ssk, and Sku are also compared. The results indicate XCT can capture re-entrant features, while FVM can capture more details. However, XCT measurement is limited in its resolution and FVM measurement is restricted by the line-of-sight constraint. The surface parameters of two measurement techniques are closer in the cases where surface texture of the parts is higher.Keywords
Funding Information
- Engineering and Physical Sciences Research Council
This publication has 8 references indexed in Scilit:
- Material ratio curve of 3D surface topography of additively manufactured parts: an attempt to characterise open surface poresSurface Topography: Metrology and Properties, 2021
- Areal topography measurement of metal additive surfaces using focus variation microscopyAdditive Manufacturing, 2019
- An interlaboratory comparison of X-ray computed tomography measurement for texture and dimensional characterisation of additively manufactured partsAdditive Manufacturing, 2018
- Characterisation of the topography of metal additive surface features with different measurement technologiesMeasurement Science and Technology, 2017
- Areal surface texture data extraction from X-ray computed tomography reconstructions of metal additively manufactured partsPrecision Engineering, 2017
- Topography of selectively laser melted surfaces: A comparison of different measurement methodsCIRP Annals, 2017
- Computed tomography for dimensional metrologyCIRP Annals, 2011
- A method for registration of 3-D shapesIEEE Transactions on Pattern Analysis and Machine Intelligence, 1992