Survey of Detection, Mitigation, and Repair Technologies to Address Problems Caused by Sensitization of Al-Mg Alloys on Navy Ships
- 22 December 2015
- journal article
- research article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 72 (2) , 314-328
Abstract
Structural aluminum alloys are used in marine applications where light weight and increased speed are paramount. The 5xxx series alloys are the ideal choice, providing an optimum combination of as-welded strength and general corrosion resistance. A particular concern is sensitization in service. Aluminum is considered sensitized when a nearly continuous network of β phase forms along the grain boundaries. The β phase is anodic to the Al matrix, and, when exposed to sea water and sufficient loading, provides a clear pathway to stress corrosion cracking (SCC). The degree of β-phase precipitation is driven by a combination of time and elevated temperature. For over a decade, SCC of Al superstructures has plagued Navy ships. To address this issue, relevant technologies have been adopted, adapted, and developed to combat this issue. More specifically, the technology areas involve the detection of sensitization, the mitigation of SCC, and the replacement of corrupt materials. The technologies discussed herein are all currently used on the waterfront, and their use is summarized in a case study at the end of this survey.Keywords
This publication has 29 references indexed in Scilit:
- A Survey of Sensitization in 5xxx Series Aluminum AlloysCorrosion, 2015
- Modeling sensitization of Al–Mg alloys via β-phase precipitation kineticsScripta Materialia, 2015
- Influence of microalloying additions on Al-Mg alloy. Part 2: Phase analysis and sensitisation behaviourCorrosion Engineering, Science and Technology: The International Journal of Corrosion Processes and Corrosion Control, 2014
- Grain boundary misorientation dependence of β phase precipitation in an Al–Mg alloyScripta Materialia, 2014
- Quantification of Sensitization in AA5083-H131 via Imaging Ga-Embrittled Fracture SurfacesCorrosion, 2012
- Evaluation of Al3Mg2 Precipitates and Mn-Rich Phase in Aluminum-Magnesium Alloy Based on Scanning Transmission Electron Microscopy ImagingMetallurgical and Materials Transactions A, 2012
- Transmission Electron Microscopic Investigations of Grain Boundary Beta Phase Precipitation in Al 5083 Aged at 373 K (100 °C)Metallurgical and Materials Transactions A, 2012
- Precipitation behavior of the ß phase in Al-5083Materials Science and Engineering: A, 2010
- Effect of thermomechanical treatment on the corrosion of AA5083Corrosion Science, 2010
- Stress corrosion cracking of sensitized AA5083 (Al-4.5Mg-1.0Mn)Metallurgical and Materials Transactions A, 2001