Aqueous Processing of Titanium Carbide Green Sheets
Authors:
- 1 November 2001
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 84 (11) , 2537-2541
Abstract
TiC sheets were prepared by an aqueous tape‐casting process. The zeta potential measurement showed that the isoelectric point for TiC powders in the absence of dispersant had a pH value of ∼3.3. According to the surface properties of TiC powders, a cationic polymer PEI was selected as dispersant. In the presence of dispersant, the isoelectric point increased to a pH value of ∼10.4. The slip stability was determined by visual observation of the fluidity of the slip as well as the settling of the powders. Results showed that the amount of dispersant required to achieve a minimum of viscosity for 50 vol% suspensions was equal to 1.2 wt%. In the absence and presence of dispersant, stable slips could be obtained in the pH ranges 7–9 and 11–12, respectively. The rheological measurements showed that with PEI as dispersant, TiC suspensions exhibited a small time dependent behavior. With polyvinyl alcohol as binder and glycerol as plasticizer, suspensions showed a thixotropic feature. As‐cast tapes were dried in air at room temperature. The results showed that it was possible to fabricate homogeneous green tapes with smooth surfaces from these suspensions.Keywords
This publication has 20 references indexed in Scilit:
- Colloidal Processing of Silicon Nitride with Poly(acrylic acid): II, Rheological PropertiesJournal of the American Ceramic Society, 1998
- Adsorption Effects on the Rheological Properties of Aqueous Alumina Suspensions with PolyelectrolyteJournal of the American Ceramic Society, 1998
- Processing of composites in aqueous mediaJournal of the European Ceramic Society, 1997
- Rheological Property and Stress Development during Drying of Tape‐Cast Ceramic LayersJournal of the American Ceramic Society, 1996
- Review: aqueous tape casting of ceramic powdersMaterials Science and Engineering: A, 1995
- Effect of Functionalities of Binders on Rheological Behavior of Alumina Suspensions and Properties of Green SheetsJournal of the Ceramic Society of Japan, 1993
- Stabilization and Processing of Aqueous BaTiO3 Suspension with Polyacrylic AcidJournal of the American Ceramic Society, 1992
- Aqueous Processing of Mullite‐Containing Green SheetsJournal of the American Ceramic Society, 1991
- Theory of DryingJournal of the American Ceramic Society, 1990
- Stability of Aqueous α‐Al 2 O 3 Suspensions with Poly(methacrylic acid) PolyelectrolyteJournal of the American Ceramic Society, 1988