Analysis of Snap-Back Instability due to End-Plate Debonding in Strengthened Beams
- 1 February 2010
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Engineering Mechanics
- Vol. 136 (2) , 199-208
Abstract
The problem of end-plate debonding of the external reinforcement in strengthened concrete beams is analyzed in this paper. As experimentally observed, this mode of failure is highly brittle and poses severe limitations to the efficacy of the strengthening technique. A numerical analysis of the full-range behavior of strengthened beams in bending is herein proposed to study the stages of nucleation and propagation of interfacial cracks between the external reinforcement and the concrete substrate. This is achieved by modeling the nonlinear interface behavior according to a cohesive law accounting for Mode Mixity. The numerically obtained load versus midspan deflection curves for three- or four-point bending beams show that the process of end-plate debonding is the result of a snap-back instability, which is fully interpreted in the framework of the Catastrophe Theory. To capture the softening branch with positive slope, the interface crack-length control scheme is proposed in the numerical simulations. The results of a wide parametric study exploring the effect of the relative reinforcement length, the mechanical percentage of fiber-reinforced polymer sheets, the beam slenderness, and the ratio between Mode II and Mode I fracture energies are collected in useful diagrams. Finally, an experimental assessment of the proposed model completes the paper.Keywords
This publication has 35 references indexed in Scilit:
- Towards a Unified Approach for the Analysis of Failure Modes in FRP-Retrofitted Concrete BeamsAdvances in Structural Engineering, 2009
- Modelling of mixed mode debonding in externally FRP reinforced beamsComposites Science and Technology, 2007
- Analysis of Scaling and Instability in FRP-Concrete Shear Debonding for Beam-Strengthening ApplicationsJournal of Engineering Mechanics, 2007
- Debonding of FRP plated concrete: A tri-layer fracture treatmentEngineering Fracture Mechanics, 2006
- Fracture Model for Flexural Failure of Beams Retrofitted with CARDIFRCJournal of Engineering Mechanics, 2003
- Modeling of composite/concrete interface of RC beams strengthened with composite laminatesComposites Part B: Engineering, 2000
- Softening and snap‐back instability in cohesive solidsInternational Journal for Numerical Methods in Engineering, 1989
- Post-peak and post-bifurcation analysis of cohesive crack propagationEngineering Fracture Mechanics, 1989
- Cusp catastrophe interpretation of fracture instabilityJournal of the Mechanics and Physics of Solids, 1989
- Interpretation of the Griffith Instability as a Bifurcation of the Global Equilibrium1985