Experimental study on two-phase boiling in wavy copper microchannels fabricated with ultrafast laser micromachining
Authors:
- Zhenyu LiuZhenyu Liu
- Xinyu YaoXYXinyu Yao
- Xiao ChengXCXiao Cheng
- Huiying WuHWHuiying Wu
- Han WangHWHan Wang
- Hong ShenHong Shen
- 7 May 2020
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 30 (6) , 065011
Abstract
In this study, the sinusoidal wavy (SW) copper microchannels with triangular cross section were fabricated with the ultrafast laser micromachining approach. The flow boiling of de-ionized water in SW microchannels were experimentally studied under mass fluxes of 43.43–217.15 kg (m 2 s) −1 and heat fluxes of 0–590 kW m −2 . The flow patterns in the SW microchannels were visually observed and the boiling heat transfer characteristics were analyzed based on the obtained data. It shows the SW microchannel has a maximum enhancement of 127.7% in the local heat transfer coefficient with an acceptable increase of pressure loss compared to the straight one in the present work. In SW microchannels, a low degree of superheat can trigger the onset of nucleate boiling. A slow decreasing tendency of local heat transfer coefficient under a high effective heat flux or a high vapor quality was observed. The heat transfer mechanism of flow boiling in SW microchannels was analyzed based on the experimental visualization. Nucleate boiling and thin film evaporation are the dominant modes under different thermal boundary conditions. The flow boiling instability phenomenon in microchannels can be diminished using the wavy structures.Keywords
Funding Information
- Shanghai International Science and Technology Cooperation Project (18160743900)
- National Natural Science Foundation of China (51536005, 51676124, 51820105009)
This publication has 28 references indexed in Scilit:
- Microheat exchanger for cooling high power laser diodesApplied Thermal Engineering, 2015
- Enhanced pool boiling heat transfer mechanisms for selectively sintered open microchannelsInternational Journal of Heat and Mass Transfer, 2015
- Flow boiling heat transfer enhancement on copper surface using Fe doped Al2O3–TiO2 composite coatingsApplied Surface Science, 2015
- Experimental investigations on flow boiling performance of reentrant and rectangular microchannels – A comparative studyInternational Journal of Heat and Mass Transfer, 2015
- An experimental study of flow friction and heat transfer in wavy microchannels with rectangular cross sectionInternational Journal of Thermal Sciences, 2011
- CFD study of liquid-cooled heat sinks with microchannel flow field configurations for electronics, fuel cells, and concentrated solar cellsApplied Thermal Engineering, 2011
- Proton exchange membrane fuel cell multi-physical dynamics and stack spatial non-homogeneity analysesJournal of Power Sources, 2010
- Fluid flow and heat transfer in wavy microchannelsInternational Journal of Heat and Mass Transfer, 2010
- Fabrication of microchannels on stainless steel by wet chemical etchingJournal of Micromechanics and Microengineering, 2007
- Describing the uncertainties in experimental resultsExperimental Thermal and Fluid Science, 1988