Influence of differential rotor speeds on the performance and acoustic emission of coaxial propellers
Open Access
- 1 January 2026
- journal article
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 159 (1) , 539-552
Abstract
This study investigated the noise emission and thrust performance of a heavy-lift unmanned air vehicle (UAV) with a coaxial propulsion system that operates under differential rotor speeds. The UAV adopted an octo-quad architecture, where each rotor pair consists of two propellers with different blades, allowing independent operation of fore and aft rotors in corotating (CR) and contra-rotating (CTR) configurations. Acoustic emissions and thrust were measured under steady conditions. The study compared the performances of CR and CTR configurations and examined the influence of differential rotor speed on the noise emission of the vehicle under different loads for both configurations. The results indicate that the CTR configuration achieves a maximum load factor 0.28 higher than that of the CR configuration and features lower noise at the same thrust when employing differential rotor speed. For both configurations, the drone's noise was influenced by the aerodynamic characteristics of propellers. Specifically, increasing the fore rotor speed relative to the aft rotor amplifies the noise, whereas increasing the aft rotor speed reduces noise without compromising thrust. Corresponding noise spectra were analyzed across different load factors. The results provide insights that can inform about the optimization of noise emission and performance of UAVs with coaxial propulsion systems.Keywords
This publication has 34 references indexed in Scilit:
- Aerodynamic model of counter-rotating coaxial rotors near the groundAerospace Science and Technology, 2025
- Aerodynamic and acoustic interactional effects for small commercial propellers in co-axial counter-rotating arrangementsAerospace Science and Technology, 2025
- Computational aeroacoustic study of co-rotating rotors in hoverAerospace Science and Technology, 2024
- An experimental investigation on the effect of in-flow distortions of propeller noiseApplied Acoustics, 2023
- Exploration of stacked rotor designs for aerodynamics in hoverAerospace Science and Technology, 2023
- Quad-copter noise measurements under realistic flight conditionsAerospace Science and Technology, 2022
- Experimental and analytical investigation of contra-rotating multi-rotor UAV propeller noiseApplied Acoustics, 2021
- A novel methodology for wing sizing of bio-inspired flapping wing micro air vehicles: theory and prototypeActa Mechanica, 2016
- Propeller Noise Reduction by Means of Unsymmetrical Blade-spacingJournal of Sound and Vibration, 1993
- Loudness, Its Definition, Measurement and Calculation*Bell System Technical Journal, 1933