Sen Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Sen Wang has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Daniele Ragni
Delft University of Technology
3 shared publications - Lourenço Tércio Lima Pereira
Department of Flow Physics and Technology, Delft University of Technology 1 , Delft, 2629 HS
2 shared publications - Andrea Magrini
Department of Industrial Engineering, Università degli Studi di Padova, 35131 Padova, Italy
1 shared publication - Federico N. Ramirez
CMT – Clean Mobility & Thermofluids, Universitat Politècnica de València 3 , Camino de Vera, 46022 Valencia
1 shared publication Hajar Chouiyakh
School of Aerospace and Automotive Engineering, International University of Rabat 1 , 11100 Sala Al Jadida
1 shared publication- Kangni Combey
International University of Rabat
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 159 (1) , 539-552
Influence of differential rotor speeds on the performance and acoustic emission of coaxial propellers
This study investigated the noise emission and thrust performance of a heavy-lift unmanned air vehicle (UAV) with a coaxial propulsion system that operates under differential rotor speeds. The UAV adopted an octo-quad architecture, where each rotor pair consists of two propellers with different blades, allowing independent operation of fore and aft rotors in corotating (CR) and contra-rotating (CTR) configurations. Acoustic emissions and thrust were measured under steady conditions. The study compared the performances of CR and CTR configurations and examined the influence of differential rotor speed on the noise emission of the vehicle under different loads for both configurations. The results indicate that the CTR configuration achieves a maximum load factor 0.28 higher than that of the CR configuration and features lower noise at the same thrust when employing differential rotor speed. For both configurations, the drone's noise was influenced by the aerodynamic characteristics of propellers. Specifically, increasing the fore rotor speed relative to the aft rotor amplifies the noise, whereas increasing the aft rotor speed reduces noise without compromising thrust. Corresponding noise spectra were analyzed across different load factors. The results provide insights that can inform about the optimization of noise emission and performance of UAVs with coaxial propulsion systems.
- 1 January 2026
- Published by Acoustical Society of America (ASA) in The Journal of the Acoustical Society of America
- Vol. 159 (1) , 539-552
Open AccessInfluence of differential rotor speeds on the performance and acoustic emission of coaxial propellers
This study investigated the noise emission and thrust performance of a heavy-lift unmanned air vehicle (UAV) with a coaxial propulsion system that operates under differential rotor speeds. The UAV adopted an octo-quad architecture, where each rotor pair consists of two propellers with different blades, allowing independent operation of fore and aft rotors in corotating (CR) and contra-rotating (CTR) configurations. Acoustic emissions and thrust were measured under steady conditions. The study compared the performances of CR and CTR configurations and examined the influence of differential rotor speed on the noise emission of the vehicle under different loads for both configurations. The results indicate that the CTR configuration achieves a maximum load factor 0.28 higher than that of the CR configuration and features lower noise at the same thrust when employing differential rotor speed. For both configurations, the drone's noise was influenced by the aerodynamic characteristics of propellers. Specifically, increasing the fore rotor speed relative to the aft rotor amplifies the noise, whereas increasing the aft rotor speed reduces noise without compromising thrust. Corresponding noise spectra were analyzed across different load factors. The results provide insights that can inform about the optimization of noise emission and performance of UAVs with coaxial propulsion systems.
- Top Cited Papers
- 1 January 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (1)
Aerodynamic and aeroacoustic interactions in multirotor aircraft for urban air mobility: A review
The rapid growth of urbanization and increasing road traffic congestion are straining ground transportation infrastructure for both conventional and emergency purposes, driving the need for alternative mobility solutions. urban air mobility (UAM) offers a promising pathway by deploying electric vertical takeoff and landing (eVTOL) aircraft to enable efficient and flexible aerial transport in dense urban environments. However, the successful integration of UAM into city airspace faces critical technical challenges, both at the vehicle and operational levels. In particular, complex aerodynamic and aeroacoustic interactions between closely spaced propellers significantly influence vehicle performance, energy efficiency, and public acceptance. This work presents a review of experimental and computational studies on propeller–propeller and propeller–wing interactions, highlighting the state-of-the-art methodologies and their application to multirotor eVTOL designs. Results indicate that distributed electric propulsion systems arranged in side-by-side configurations exhibit minimal thrust degradation, typically less than 3% compared to an isolated propeller. However, reductions in propeller spacing can induce unsteady blade loading and increase tonal noise levels by up to 10 dB. In contrast, one-after-another configurations may suffer thrust losses of up to 80%, due to slipstream ingestion by the rear propeller, with a lateral separation of at least twice the propeller radius required to recover performance within 4% of the isolated case. The review also addresses propeller–wing interactions that modify local pressure distributions and spanwise lift, particularly in wing-mounted distributed propulsion configurations. The insights provided establish a foundation for developing efficient, low-noise multirotor architectures for future UAM integration.
- 1 January 2026
- Published by AIP Publishing in Physics of Fluids
- Vol. 38 (1)
Top Cited PapersAerodynamic and aeroacoustic interactions in multirotor aircraft for urban air mobility: A review
The rapid growth of urbanization and increasing road traffic congestion are straining ground transportation infrastructure for both conventional and emergency purposes, driving the need for alternative mobility solutions. urban air mobility (UAM) offers a promising pathway by deploying electric vertical takeoff and landing (eVTOL) aircraft to enable efficient and flexible aerial transport in dense urban environments. However, the successful integration of UAM into city airspace faces critical technical challenges, both at the vehicle and operational levels. In particular, complex aerodynamic and aeroacoustic interactions between closely spaced propellers significantly influence vehicle performance, energy efficiency, and public acceptance. This work presents a review of experimental and computational studies on propeller–propeller and propeller–wing interactions, highlighting the state-of-the-art methodologies and their application to multirotor eVTOL designs. Results indicate that distributed electric propulsion systems arranged in side-by-side configurations exhibit minimal thrust degradation, typically less than 3% compared to an isolated propeller. However, reductions in propeller spacing can induce unsteady blade loading and increase tonal noise levels by up to 10 dB. In contrast, one-after-another configurations may suffer thrust losses of up to 80%, due to slipstream ingestion by the rear propeller, with a lateral separation of at least twice the propeller radius required to recover performance within 4% of the isolated case. The review also addresses propeller–wing interactions that modify local pressure distributions and spanwise lift, particularly in wing-mounted distributed propulsion configurations. The insights provided establish a foundation for developing efficient, low-noise multirotor architectures for future UAM integration.
- Open Access
- 13 February 2025
- Published by Elsevier in Aerospace Science and Technology
- Vol. 160
Design exploration of UAM vehicles
- 13 February 2025
- Published by Elsevier in Aerospace Science and Technology
- Vol. 160
Open AccessDesign exploration of UAM vehicles