Predictive Modeling for Detection of Source of Electromagnetic Disturbances in Inductive Wireless Charging of Electric Vehicles
- 27 January 2022
- journal article
- research article
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 69 (10) , 7541-7552
Abstract
The effects of Electromagnetic Interference (EMI) in Inductive Power Transfer (IPT) for electric vehicle charging circuits are elaborated with Common Mode (CM) emission. Electromagnetic Compatibility (EMC) has to be sustained in the circuits such that it is prone to the effects of interferences, noises and disturbances. These issues can be addressed at the initial product development stage, with accurate identification of the parameters that influence the CM emission in the circuit. The analysis of EMI focuses on three features, namely Source of EMI, Coupling path and Receptor. In the IPT model, the primary source of the EMI is the power converter used for high-frequency supply to the inductive coils. The power converter switches and the heat sink with its Printed Circuit Board (PCB) design are predominant in power electronic circuits. This paper facilitates the reduction of EMI without including complex filters. The system is tested for the violated standard SAEJ2954. In addition, the article corroborates precognitive modeling by implementing compensation networks used in IPT applications and their effectiveness in reducing the leakage current caused by the converters and the coils. The paper insights the air gap variation of the coil with the power transfer efficiency and its influence on electromagnetic interferences. The Fast Fourier Transform (FFT) analysis used in PSIM shows leakage current and harmonic reduction with the compensation network and Pulse Width Modulation (PWM) technique. The fabrication model for the front end power supply to the IPT is tested. The electrical noise emission is estimated using predictive modeling.Keywords
This publication has 23 references indexed in Scilit:
- Wireless Power Transfer for Vehicular Applications: Overview and ChallengesIEEE Transactions on Transportation Electrification, 2017
- The Future ofWireless Power2017
- Introduction to Mobile Power Electronics2017
- Common Mode Noise Propagation and Effects in a Four-Wheel Drive Electric VehicleIEEE Transactions on Electromagnetic Compatibility, 2017
- A General Calibration Procedure for Measuring RF Voltages and Currents Applied to the EMC Analysis of Automotive High-Voltage Power NetworksIEEE Transactions on Electromagnetic Compatibility, 2015
- ORNL Experience and Challenges Facing Dynamic Wireless Power Charging of EV'sIEEE Circuits and Systems Magazine, 2015
- The Inductive Power Transfer Story at the University of AucklandIEEE Circuits and Systems Magazine, 2015
- A Survey of Wireless Power Transfer and a Critical Comparison of Inductive and Capacitive Coupling for Small Gap ApplicationsIEEE Transactions on Power Electronics, 2015
- Advances in Wireless Power Transfer Systems for Roadway-Powered Electric VehiclesIEEE Journal of Emerging and Selected Topics in Power Electronics, 2014
- Design, modeling and simulation of DC-DC converter2010