Kripalakshmi Thiagarajan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kripalakshmi Thiagarajan has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
- Thangavelusamy Deepa
School of Electrical Engineering, Vellore Institute of Technology, Chennai, India
2 shared publications
Latest Publications
- 27 January 2022
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 69 (10) , 7541-7552
Predictive Modeling for Detection of Source of Electromagnetic Disturbances in Inductive Wireless Charging of Electric Vehicles
The effects of Electromagnetic Interference (EMI) in Inductive Power Transfer (IPT) for electric vehicle charging circuits are elaborated with Common Mode (CM) emission. Electromagnetic Compatibility (EMC) has to be sustained in the circuits such that it is prone to the effects of interferences, noises and disturbances. These issues can be addressed at the initial product development stage, with accurate identification of the parameters that influence the CM emission in the circuit. The analysis of EMI focuses on three features, namely Source of EMI, Coupling path and Receptor. In the IPT model, the primary source of the EMI is the power converter used for high-frequency supply to the inductive coils. The power converter switches and the heat sink with its Printed Circuit Board (PCB) design are predominant in power electronic circuits. This paper facilitates the reduction of EMI without including complex filters. The system is tested for the violated standard SAEJ2954. In addition, the article corroborates precognitive modeling by implementing compensation networks used in IPT applications and their effectiveness in reducing the leakage current caused by the converters and the coils. The paper insights the air gap variation of the coil with the power transfer efficiency and its influence on electromagnetic interferences. The Fast Fourier Transform (FFT) analysis used in PSIM shows leakage current and harmonic reduction with the compensation network and Pulse Width Modulation (PWM) technique. The fabrication model for the front end power supply to the IPT is tested. The electrical noise emission is estimated using predictive modeling.
- 27 January 2022
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 69 (10) , 7541-7552
Predictive Modeling for Detection of Source of Electromagnetic Disturbances in Inductive Wireless Charging of Electric Vehicles
The effects of Electromagnetic Interference (EMI) in Inductive Power Transfer (IPT) for electric vehicle charging circuits are elaborated with Common Mode (CM) emission. Electromagnetic Compatibility (EMC) has to be sustained in the circuits such that it is prone to the effects of interferences, noises and disturbances. These issues can be addressed at the initial product development stage, with accurate identification of the parameters that influence the CM emission in the circuit. The analysis of EMI focuses on three features, namely Source of EMI, Coupling path and Receptor. In the IPT model, the primary source of the EMI is the power converter used for high-frequency supply to the inductive coils. The power converter switches and the heat sink with its Printed Circuit Board (PCB) design are predominant in power electronic circuits. This paper facilitates the reduction of EMI without including complex filters. The system is tested for the violated standard SAEJ2954. In addition, the article corroborates precognitive modeling by implementing compensation networks used in IPT applications and their effectiveness in reducing the leakage current caused by the converters and the coils. The paper insights the air gap variation of the coil with the power transfer efficiency and its influence on electromagnetic interferences. The Fast Fourier Transform (FFT) analysis used in PSIM shows leakage current and harmonic reduction with the compensation network and Pulse Width Modulation (PWM) technique. The fabrication model for the front end power supply to the IPT is tested. The electrical noise emission is estimated using predictive modeling.
- 6 April 2021
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 69 (5) , 2761-2771
A Comprehensive Review of High-frequency Transmission Inverters for Magnetic Resonance Inductive Wireless Charging Applications in Electric Vehicles
This paper presents a detailed review of the design aspects and performance analysis of high-frequency inverters used in inductive power transfer application (IPT) for electric vehicles. The paper’s main scope is focused on the design of inverters used explicitly for wireless charging with misalignment variations and coil dimensions. The research articles in the literature focus on the high-power transfer and coil structures for the existing topologies. The magnetic resonance coupling in the IPT system depends on the resonance phenomenon. The operating frequency of the inverter must be the same as the resonant frequency in the compensation network. On complete assessments, the paper emphases on suitable inverter specifications for wireless charging and its related issues. In addition, the resonant inverters can be replaced with H-bridge inverters in consideration of voltage stress and harmonic control. Investigations on harmonic elimination strategies for H-bridge and resonant inverters are also discussed in the paper.
- 6 April 2021
- Published by Taylor & Francis in IETE Journal of Research
- Vol. 69 (5) , 2761-2771
A Comprehensive Review of High-frequency Transmission Inverters for Magnetic Resonance Inductive Wireless Charging Applications in Electric Vehicles
This paper presents a detailed review of the design aspects and performance analysis of high-frequency inverters used in inductive power transfer application (IPT) for electric vehicles. The paper’s main scope is focused on the design of inverters used explicitly for wireless charging with misalignment variations and coil dimensions. The research articles in the literature focus on the high-power transfer and coil structures for the existing topologies. The magnetic resonance coupling in the IPT system depends on the resonance phenomenon. The operating frequency of the inverter must be the same as the resonant frequency in the compensation network. On complete assessments, the paper emphases on suitable inverter specifications for wireless charging and its related issues. In addition, the resonant inverters can be replaced with H-bridge inverters in consideration of voltage stress and harmonic control. Investigations on harmonic elimination strategies for H-bridge and resonant inverters are also discussed in the paper.