Monitoring the morphology development of polymer‐monolithic stationary phases by thermal analysis
- 24 October 2013
- journal article
- research article
- Published by Wiley in Journal of Separation Science
- Vol. 37 (1-2) , 179-186
Abstract
Thermal analysis and SEM were employed to gain insights in the different stages of morphology development and the thermal properties of polymer‐monolithic stationary phases. The studied system was a thermally initiated free‐radical copolymerization reaction at 70°C of styrene and divinylbenzene in the presence of tetrahydrofuran and 1‐decanol. The key events in the early stages of morphology development are initiation, chain growth, branching, and cyclization, leading to microgel particles. Interparticle reactions through pendant vinyl groups lead to the formation of microgel clusters. The rapid increase in molecular weight and cross‐link density of the microgel clusters causes a reaction‐induced phase separation, and the formation of a macroscopic network of interconnected globules was observed (macrogelation) at around 45 min. After 3 h or 65% conversion, a space‐filling macroporous monolithic network was observed. Afterwards, mainly growth of existing globules takes place, reducing the macropore size. The porogen ratio affects the timing of the reaction‐induced phase separation, strongly influencing the morphology of the polymer material. The use of a mixture of divinylbenzene isomers yielded a monolithic material that is less cross‐linked at the surface compared to the central part of the polymer backbone due to copolymerization‐composition drift. The less cross‐linked outer layer starts devitrifying at 100°C.Keywords
This publication has 32 references indexed in Scilit:
- High-resolution separations of protein isoforms with liquid chromatography time-of-flight mass spectrometry using polymer monolithic capillary columnsJournal of Chromatography A, 2011
- Porous polymer monoliths: Amazingly wide variety of techniques enabling their preparationJournal of Chromatography A, 2010
- 1 mm ID poly(styrene‐co‐divinylbenzene) monolithic columns for high‐peak capacity one‐ and two‐dimensional liquid chromatographic separations of intact proteinsJournal of Separation Science, 2009
- Effect of polymerization conditions on morphology and chromatographic characteristics of polyacrylamide‐based beds (monoliths) for capillary electrochromatography and capillary liquid chromatographyJournal of Separation Science, 2009
- Downscaling Limits and Confinement Effects in the Miniaturization of Porous Polymer Monoliths in Narrow Bore CapillariesAnalytical Chemistry, 2009
- Optimization of the porous structure and polarity of polymethacrylate‐based monolithic capillary columns for the LC‐MS separation of enzymatic digestsJournal of Separation Science, 2007
- Latex-functionalized monolithic columns for the separation of carbohydrates by micro anion-exchange chromatographyJournal of Chromatography A, 2004
- Effect of porosity and surface chemistry on the characterization of synthetic polymers by HPLC using porous polymer monolithic columnsJournal of Separation Science, 2002
- Modulated differential scanning calorimetry: isothermal cure and vitrification of thermosetting systemsThermochimica Acta, 1995
- Free-radical crosslinking copolymerization of styrene/unsaturated polyester resins: 2. Electron spin resonance studyPolymer, 1993