Influence of geometric parameters on the thermal hydraulic performance of an ellipsoidal protruded enhanced tube
- 18 July 2017
- journal article
- research article
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 72 (2) , 153-170
Abstract
In this paper, the numerical simulation model of an ellipsoidal protruded tube has been established considering thermal hydraulic performance. The flow field characteristics and heat transfer characteristics of an ellipsoidal protruded tube were investigated. Effects of protrusion configuration, depth, pitch, number, axis ratio, and angle on thermal hydraulic performance were discussed using the realizable k–ε model under the steady-state condition. These results show that protrusion volume has a major impact on thermal hydraulic performance. The protrusions make the zone of flows narrow down at the protrusion leading edge side and expand at the trailing edge side, which resulted in protrusions increased turbulence, flow mixing, flow separation, and boundary layer distribution, thus enhancing the heat transfer performance. The maximum of local Nusselt number is located at the protrusions leading edge, and the minimum of local pressure is located at central of the protrusion surface. The configuration has no significant effect on the thermal hydraulic performance. Furthermore, the optimal selection of parameters boosts the heat transfer by up to 130.9% and amplifies the pressure loss up to 103.2%.Keywords
Funding Information
- Key Laboratory of Efficient & Clean Energy Utilization, The Education Department of Hunan Province (2017NGQ004)
- Graduate Innovation Foundation of School of Mechatronic Engineering of SWPU (CX2014SY30)
This publication has 20 references indexed in Scilit:
- Flow Regime Determination for Finned Heat Exchanger Surfaces with Dimples/ProtrusionsNumerical Heat Transfer, Part A: Applications, 2013
- Three-Dimensional Numerical Study of Fluid and Heat Transfer Characteristics of Dimpled Fin SurfacesNumerical Heat Transfer, Part A: Applications, 2012
- The influence of artificial roughness shape on heat transfer enhancement: Corrugated tubes, dimpled tubes and wire coilsApplied Thermal Engineering, 2012
- Heat transfer and hydrodynamics analysis of a novel dimpled tubeExperimental Thermal and Fluid Science, 2010
- Shape Optimization of a Dimpled Channel to Enhance Heat Transfer Using a Weighted-Average Surrogate ModelHeat Transfer Engineering, 2010
- Compound heat transfer enhancement of a dimpled tube with a twisted tape swirl generatorInternational Communications in Heat and Mass Transfer, 2009
- Heat Transfer and Friction Characteristics for Turbulent Flow of Dimpled TubesChemical Engineering & Technology, 2009
- Heat transfer and pressure drop for low Reynolds turbulent flow in helically dimpled tubesInternational Journal of Heat and Mass Transfer, 2002
- Heat transfer enhancement in dimpled tubesApplied Thermal Engineering, 2001
- Forced convection heat transfer in helically rib-roughened tubesInternational Journal of Heat and Mass Transfer, 1980