A Dividerless Ring Oscillator PLL With 250fs Integrated Jitter Using Sampled Lowpass Filter
- 28 February 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 67 (11) , 2337-2341
Abstract
This work presents a novel ring oscillator based phase lock loop architecture that is capable of wideband, dividerless integer-N synthesis. The noise transfer function of the presented architecture is the same as a sub-sampling phase lock loop (PLL). Like a sub-sampling PLL, the presented architecture removes the phase detector and charge pump’s N2 noise that dominates the in-band noise of traditional PLLs. This noise reduction allows the presented ring oscillator PLL to operate with integrated jitter as low as 250fs. Unlike sub-sampling PLLs, the presented architecture moves the sampling block downstream of the loop filter. As the sampled data is lowpass filtered, only low frequency sampling blocks are required, which removes the power and area overheads associated with directly sampling the voltage controlled oscillator. Measurement results show the presented PLL is capable of locking over a wide range of 1.2-2.5GHz. The presented PLL is fabricated in 65nm bulk CMOS, and demonstrates a figure of merit of -242.7dB, which is among best in class for ring oscillator PLLs. Furthermore, an area of 0.0066 mm is consumed, which represents the smallest published sub-sampling ring oscillator PLLs.Keywords
Funding Information
- Defense Advanced Research Project Agency (D16AP00094)
This publication has 16 references indexed in Scilit:
- A −242-dB FOM and −71-dBc reference spur ring-VCO-based ultra-low-jitter switched-loop-filter PLL using a fast phase-error correction technique2017
- A low-noise inductor-less fractional-N sub-sampling PLL with multi-ring oscillator2017
- A 2-GHz Pulse Injection-Locked Rotary Traveling-Wave OscillatorIEEE Transactions on Microwave Theory and Techniques, 2016
- 10.7 A 185fsrms-integrated-jitter and −245dB FOM PVT-robust ring-VCO-based injection-locked clock multiplier with a continuous frequency-tracking loop using a replica-delay cell and a dual-edge phase detector2016
- Hold-In, Pull-In, and Lock-In Ranges of PLL Circuits: Rigorous Mathematical Definitions and Limitations of Classical TheoryIEEE Transactions on Circuits and Systems I: Regular Papers, 2015
- Low-Phase Noise Clock Distribution Network Using Rotary Traveling-Wave Oscillators and Built-In Self-Test Phase Tuning TechniqueIEEE Transactions on Circuits and Systems II: Express Briefs, 2014
- Spur Reduction Techniques for Phase-Locked Loops Exploiting A Sub-Sampling Phase DetectorIEEE Journal of Solid-State Circuits, 2010
- A Low Noise Sub-Sampling PLL in Which Divider Noise is Eliminated and PD/CP Noise is Not Multiplied by $N ^{2}$IEEE Journal of Solid-State Circuits, 2009
- Design Techniques for a Pipelined ADC Without Using a Front-End Sample-and-Hold AmplifierIEEE Transactions on Circuits and Systems I: Regular Papers, 2004
- A simple precharged CMOS phase frequency detectorIEEE Journal of Solid-State Circuits, 1998