A 0.9-V DAC-Calibration-Free Continuous-Time Incremental Delta–Sigma Modulator Achieving 97-dB SFDR at 2 MS/s in 28-nm CMOS
- 30 March 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 57 (11) , 3407-3417
Abstract
This article shows the design of a wideband 3-0 sturdy-multi-stage noise-shaping (SMASH) continuous-time (CT) incremental delta–sigma (I- $\boldsymbol {\Delta \Sigma }$ ) analog-to-digital converter (ADC). The two stages’ quantizers (QTZs) are implemented by a single re-configurable multibit (MB) asynchronous (A)SAR ADC. The digital-to-analog converter (DAC) nonlinearities are suppressed by reconfiguring the asynchronous successive-approximation register (ASAR) ADC from 2 to 5 b, and correspondingly, the DACs dynamically switch from 1.5- to 4-b tri-level outputs within each Nyquist conversion cycle. This results in a DAC-calibration-free MB operation. A two-tap FIR filter is implemented in the feedback DACs to reduce jitter requirements in the initial 1.5-b cycles. Through the design representation, a detailed fundamental comparison between an X-0 SMASH architecture and an X-order single-loop modulator is discussed. This discussion highlights the introduction of an efficient tri-level combination between the MSB and the LSBs of the ASAR QTZ. The resulting SMASH CT I- $\boldsymbol {\Delta \Sigma }$ modulator was fabricated in 28-nm CMOS technology with an active area of 0.125 mm2. It achieves 97-dB spurious-free dynamic range (SFDR) without calibration, 89-dB dynamic range (DR), and 81.2-dB SNDR in a 1-MHz bandwidth (BW). It consumes 3.6 mW from a single 0.9-V supply. The design shows very good robustness across different tested samples, supply variations, and across temperatures from −20 °C to 80 °C.Keywords
Funding Information
- German Research Foundation through Deutsche Forschungsgemeinschaft (OR 245/13-1)
This publication has 39 references indexed in Scilit:
- A Power-Efficient Continuous-Time Incremental Sigma-Delta ADC for Neural Recording SystemsIEEE Transactions on Circuits and Systems I: Regular Papers, 2015
- A Micro-Power Two-Step Incremental Analog-to-Digital ConverterIEEE Journal of Solid-State Circuits, 2015
- Low Power Design Techniques for Single-Bit Audio Continuous-Time Delta Sigma ADCs Using FIR FeedbackIEEE Journal of Solid-State Circuits, 2014
- Calibration of DAC Mismatch Errors in $\Sigma\Delta$ ADCs Based on a Sine-Wave MeasurementIEEE Transactions on Circuits and Systems II: Express Briefs, 2013
- An 8.5 mW Continuous-Time $\Delta \Sigma $ Modulator With 25 MHz Bandwidth Using Digital Background DAC Linearization to Achieve 63.5 dB SNDR and 81 dB SFDRIEEE Journal of Solid-State Circuits, 2011
- A 26 $\mu$W 8 bit 10 MS/s Asynchronous SAR ADC for Low Energy RadiosIEEE Journal of Solid-State Circuits, 2011
- 74 dB SNDR Multi-Loop Sturdy-MASH Delta-Sigma Modulator Using 35 dB Open-Loop Opamp GainIEEE Journal of Solid-State Circuits, 2009
- A Low-Power 22-bit Incremental ADCIEEE Journal of Solid-State Circuits, 2006
- Theory and Applications of Incremental$Delta Sigma $ConvertersIEEE Transactions on Circuits and Systems I: Regular Papers, 2004
- A 1.5-v 12-bit power-efficient continuous-time third-order ΣΔ modulatorIEEE Journal of Solid-State Circuits, 2003