Research on Dual-Motor Redundant Compensation for Unstable Fluid Load of Control Valves
Open Access
Abstract
Control valves are widely applied in nuclear power, offshore oil/gas extraction, and chemical engineering, but suffer from issues like pressure oscillation, flow control accuracy degradation, and motor overload due to unstable fluid loads (e.g., nuclear reactions in power plants and complex marine climates). This paper proposes a dual-motor redundant compensation method to address these challenges. The core lies in a control strategy where a single main motor drives the valve under normal conditions, while a redundant motor intervenes when load torque exceeds a preset threshold—calculated via the valve core’s fluid load model. By introducing excess load torque as positive feedback to the current loop, the method coordinates torque output between the two motors. AMESim and Matlab/Simulink joint simulations compare single-motor non-compensation, single-motor compensation, and dual-motor schemes. Results show that under inlet pressure step changes, the dual-motor compensation scheme shortens the stabilization time of the valve’s controlled variable by 40%, reduces overshoot by 65%, and decreases motor torque fluctuation by 50%. This redundant design enhances fault tolerance, providing a novel approach for reliability enhancement of deep-sea oil/gas control valves.Keywords
Funding Information
- National Natural Science Foundation of China (52275259, 2022TSGC2028, 2019GHY112052, ZR2024QE437)
- Shandong Province Science and Technology Small and Medium Enterprises Innovation Ability Enhancement Project (52275259, 2022TSGC2028, 2019GHY112052, ZR2024QE437)
- Key Research and Development Project of Shandong Province (52275259, 2022TSGC2028, 2019GHY112052, ZR2024QE437)
- Shandong Province Natural Science Foundation of China (52275259, 2022TSGC2028, 2019GHY112052, ZR2024QE437)
- Key Laboratory of High-efficiency and Clean Mechanical Manufacture at Shandong University, Ministry of Education (52275259, 2022TSGC2028, 2019GHY112052, ZR2024QE437)
This publication has 21 references indexed in Scilit:
- Position control of water hydraulic high-speed on-off valves-controlled cylinder of water hydraulic manipulatorNuclear Engineering and Design, 2025
- Simulation of renewable energy source integration in a smart energy grid using MATLAB/SimulinkNext Energy, 2025
- A review on the sizing and selection of control valves for thermal hydraulics for reactor system applicationsProgress in Nuclear Energy, 2023
- Investigation on unstable fluid load compensation of a diverged flow poppet valveEnergy Reports, 2022
- Design of control valve with low energy consumption based on Isight platformEnergy, 2022
- Modeling, simulation and experimental validation of flow rate of electro-hydraulic hitch control valve of agricultural tractorFlow Measurement and Instrumentation, 2021
- Valve core shapes analysis on flux through control valves in nuclear power plantsNuclear Engineering and Technology, 2020
- Analysis of a proportional control valve flow coefficient with the usage of a CFD methodFlow Measurement and Instrumentation, 2017
- Reduction of the flow forces in a small hydraulic seat valve as alternative approach to improve the valve characteristicsEnergy Conversion and Management, 2015
- Integration of non-linear H ∞∞ and sliding mode control techniques for motion control of a permanent magnet synchronous motorIET Electric Power Applications, 2010