Efficacy of multi-mode adhesive systems on dentin wettability and microtensile bond strength of resin composite
- 24 May 2018
- journal article
- research article
- Published by Taylor & Francis in Journal of Adhesion Science and Technology
- Vol. 32 (21) , 2405-2418
Abstract
Purpose: To evaluate the wetting ability and the microtensile bond strength of adhesive systems in various depths of dentin. Materials and Method: 48 extracted human molars cut in half in buccolingual direction. Buccal and lingual surfaces were used to obtain deep (n = 48) and superficial (n = 48) dentin. Groups were divided into 4 subgroups: Self-etch (CSE), etch&rinse (SB), multi-mode self-etch (SAU) and multimode etch&rinse (EAU) adhesive systems. 3 consecutive contact-angle measurements were obtained: T0- 3 μl drop of distilled water on dentin; T1-Droplet of the adhesive; T2- Distilled water after polymerization of the adhesive. After composite build-ups, microtensile measurements were performed. Contact angle data were analysed with analysis of variance for repeated measures. Bond strength data were analyzed by repeated measures analysis of variance, comparisons were made according to the logarithmic values (p < 0.05). Results: The difference between groups was not significant regardless of dentin depth for all measurements (p < 0.05). All groups except CSE enhanced the wetting ability of the adhesive but reduced the wetting ability of distilled water after application of the adhesive (p < 0.05). Regarding adhesive systems, the groups showed no significant difference between bond strengths to various depths of dentin except SAU (p > 0.05); in SAU, bond strength to deep dentine were significantly higher than superficial dentin (p < 0.05). Regarding adhesives’ bond strength, CSE showed significantly greater values than the other groups (p < 0.05). Conclusion: The cavity depth does not affect the bonding ability for all adhesive systems; self-etch adhesive systems might be a better choice since different adhesives may influence the wetting ability and microtensile bond strength of the dentin substrates.Keywords
This publication has 43 references indexed in Scilit:
- Immediate bonding properties of universal adhesives to dentineJournal of Dentistry, 2013
- Self-etch Monomer-Calcium Salt Deposition on DentinJournal of Dental Research, 2011
- Solvent composition of one-step self-etch adhesives and dentine wettabilityJournal of Dentistry, 2011
- Dentin wetting by three adhesive systems: Influence of etching time, temperature and relative humidityJournal of Dentistry, 2010
- Effect of salivary esterase on the integrity and fracture toughness of the dentin‐resin interfaceJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2010
- A review of adhesion scienceDental Materials, 2010
- Enamel bonding of single-step self-etch adhesives: Influence of surface energy characteristicsJournal of Dentistry, 2010
- Durability of Resin-Dentin Bonds to Water- vs. Ethanol-saturated DentinJournal of Dental Research, 2009
- In vitro analysis of ‘smear layer’ on human dentine using ac-impedance spectroscopyJournal of Dentistry, 2004
- Correlation among dentin depth, permeability, and bond strength of adhesive resinsDental Materials, 1990