High temperature fatigue characteristics of P/M and hot-forged W-Re and TZM for X-ray target of CT scanner
Authors:
- Mohd Azhar HarimonMHMohd Azhar Harimon
- Yukio MiyashitaYMYukio Miyashita
- Yuichi OtsukaYOYuichi Otsuka
- Yoshiharu MutohYMYoshiharu Mutoh
- Shinichi YamamotoSYShinichi Yamamoto
- 1 January 2018
- journal article
- research article
- Published by Elsevier in Materials & Design
- Vol. 137, 335-344
Abstract
No abstract availableKeywords
This publication has 32 references indexed in Scilit:
- Hardening mechanisms and recrystallization behaviour of several molybdenum alloysInternational Journal of Refractory Metals and Hard Materials, 2006
- Monotonic and cyclic crack growth response of a Mo–Si–B alloyActa Materialia, 2006
- Microstructure, High Temperature Strength and CO-Gas Emission of Liquid-Phase Sintered and Forged Low Oxygen TiC-ZrC-Mo AlloyJournal of the Society of Materials Science, Japan, 2006
- Improvement in Recrystallization Temperature and Mechanical Properties of a Commercial TZM Alloy through Microstructure Control by Multi-Step Internal NitridingMATERIALS TRANSACTIONS, 2005
- High temperature isothermal and thermomechanical fatigue on a molybdenum-based alloyMaterials Science and Engineering: A, 1998
- The 700 °C tensile behavior of Mo-0.5Ti-0.08Zr-0.025C (TZM) extruded bar measured transverse and parallel to the billet extrusion axisInternational Journal of Refractory Metals and Hard Materials, 1998
- Microstructure and plasticity of two molybdenum-base alloys (TZM)Materials Science and Engineering: A, 1993
- Tensile and low-cycle fatigue measurements on cross-rolled tungstenJournal of Nuclear Materials, 1981
- Yielding and fracture in tungsten and tungsten-rhenium alloysJournal of the Less Common Metals, 1969
- Tensile properties of tungsten-3% rhenium from 1400° to 2900°C in vacuumJournal of the Less Common Metals, 1964