Mechanical Integrity Analysis of a Printed Circuit Heat Exchanger with Channel Misalignment
Open Access
- 22 March 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (6) , 2169
Abstract
Printed circuit heat exchangers (PCHEs), which are used for thermal heat storage and power generation, are often subject to severe pressure and temperature differences between primary and secondary channels, which causes mechanical integrity problems. PCHE operation may result in discontinuity, such as channel misalignment, due to non-uniform thermal fields in the diffusion bonding process. The present paper analyzes the mechanical integrity, including the utilization factors of stress and deformation under various channel misalignment conditions. The pressure difference of the target PCHE is 19.5 MPa due to the high pressure (19.7 MPa) of the steam channel in the Rankine cycle and the low pressure (0.5 MPa) of molten salt or liquid metal in the primary channel. Additionally, the temperature difference between channels is around 25 °C, however the average temperature is around 500 °C. The PCHE has a relatively large primary channel measuring approximately 3 x 3 mm, and a steam channel measuring 2 x 1.5 mm. The finite element method (FEM) is applied to determine the stress by changing the misalignment to below 30% of the primary channel width. It was found that the current PCHE is operable up to 700 °C in terms of the ASME code under these design conditions. Additionally, the change of utilization factor due to the misalignment increases, but is still under the ASME acceptance criteria of 700 °C; however, it violates the criteria at 725 °C, which is the allowable temperature condition. Therefore, the mechanical integrity of the PCHE with low-pressure molten salt or liquid metal and a high-pressure steam channel is acceptable in terms of utilization factor.Keywords
Funding Information
- National Research Foundation of Korea (2017M2A8A4018624)
This publication has 18 references indexed in Scilit:
- Comparative analysis of compact heat exchangers for application as the intermediate heat exchanger for advanced nuclear reactorsAnnals of Nuclear Energy, 2015
- A review of heat transfer and pressure drop characteristics of single and two-phase microchannelsInternational Journal of Heat and Mass Transfer, 2014
- Structural assessment of intermediate printed circuit heat exchanger for sodium-cooled fast reactor with supercritical CO2 cycleAnnals of Nuclear Energy, 2014
- Thermal hydraulic performance testing of printed circuit heat exchangers in a high-temperature helium test facilityApplied Thermal Engineering, 2014
- Assessment of straight, zigzag, S-shape, and airfoil PCHEs for intermediate heat exchangers of HTGRs and SFRsNuclear Engineering and Design, 2014
- Structural Integrity Evaluation of a Lab-Scale PCHE Prototype under the Test Conditions of HELPScience and Technology of Nuclear Installations, 2013
- Development of structural design procedure of plate-fin heat exchanger for HTGRNuclear Engineering and Design, 2013
- Hydraulic performance of a microchannel PCHEApplied Thermal Engineering, 2010
- Finite element analysis of cylindrical pressure vessels having a misalignment in a circumferential jointInternational Journal of Pressure Vessels and Piping, 2010
- Heat transfer in heat exchangers of sodium cooled fast reactor systemsNuclear Engineering and Design, 2009