Edge Trimming of Aluminum Sheets Using Shear Slitting at a Rake Angle
Authors:
- 30 May 2006
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 128 (4) , 866-873
Abstract
Edge burr is inevitably present at a slit edge when an aluminum web is shear slit by a pair of rotary knives (or blades) engaged and rotated in opposite directions. This paper presents a new method of shear slitting for an aluminum sheet to produce very low edge burr height, for use in edge trimming. The method uses the same bottom rotary blade as in the traditional shear slitting, but a revised top blade that forms a rake angle with respect to the bottom blade. The top blade edge is chamfered so that the surface of the top blade edge is parallel to the surface of the bottom blade edge to produce a pair of shearing surfaces to shear slit the aluminum sheet. A sequential set of micrographs of an aluminum slit edge are taken to visualize different stages of the shear slitting process. The observation indicates that this new slitting configuration induces a local tension as a result of blade relative motion so that a combined tension∕shear is applied to the aluminum sheet to facilitate early separation in the aluminum sheets. As a result, a clean edge with very small burr height is produced consistently. Edge trimming of aluminum sheet over a wide range of slitting conditions indicates that the new configuration is insensitive to blade gap and overlap, and can lead to a clean cut with very low edge burr height even when two blades are separated by a gap that is a few times of the sheet thickness.Keywords
This publication has 9 references indexed in Scilit:
- Burr Height in Shear Slitting of Aluminum WebsJournal of Manufacturing Science and Engineering, 2005
- Dynamic Steady-State Stress Field in a Web During SlittingJournal of Applied Mechanics, 2005
- Micromechanisms of deformation and fracture in shearing aluminum alloy sheetInternational Journal of Mechanical Sciences, 2000
- An experimental investigation on cut surface and burr in trimming aluminum autobody sheetInternational Journal of Mechanical Sciences, 2000
- A Study of Burr Formation Processes Using the Finite Element Method: Part IJournal of Engineering Materials and Technology, 1999
- A Study of Burr Formation Processes Using the Finite Element Method: Part II—The Influences of Exit Angle, Rake Angle, and Backup Material on Burr Formation ProcessesJournal of Engineering Materials and Technology, 1999
- The Role of Blade Sharpness in Cutting Instabilities of Polyethylene TerephthalateJournal of Materials Science Letters, 1999
- Mechanics of slitting and cutting websExperimental Mechanics, 1998
- Burr/Breakout Model Development and Experimental VerificationJournal of Engineering Materials and Technology, 1996