Solid-Oxide Amperometric Sensor for Hydrogen Detection in Air
Open Access
- 11 May 2023
- journal article
- research article
- Published by MDPI AG in Chemengineering
- Vol. 7 (3) , 45
Abstract
An amperometric sensor based on CaZr0.95Sc0.05O3−δ (CZS) proton-conducting oxide for the measurement of hydrogen concentration in air was designed and tested. Dense CZS ceramics were fabricated through uniaxial pressing the powder synthesized by the solid-state method and sintering at 1650 °C for 2 h. The conductivity of CZS was shown to increase with increasing air humidity, which indicates the proton type of conductivity. The sensor was made from two CZS plates, one of which had a cavity was drilled to form an inner chamber, that were then pressed against each other and sealed around the perimeter to prevent gas leaking. The inner chamber of the sensor was connected with the outer atmosphere via an alumina ceramic capillary, which acted as a diffusion barrier. The sensor performance was studied in the temperature range of 600–700 °C in the mixtures of air with hydrogen. The sensor signal, or the limiting current, was found to linearly increase with the hydrogen concentration, which simplifies the sensor calibration. The sensor demonstrated a high sensitivity of ~60 μA per 1% H2 at 700 °C, a fast response, high reproducibility, good selectivity, and long-term stability.Keywords
This publication has 23 references indexed in Scilit:
- Electrical conductivity of CaZr1 − x (x = 0.01–0.20) in dry and humid airInorganic Materials, 2014
- Solid-state gas sensors for high temperature applications – a reviewJournal of Materials Chemistry A, 2014
- Hydrogen Gas Sensors Based on Semiconductor Oxide NanostructuresSensors, 2012
- Nitride and oxide semiconductor nanostructured hydrogen gas sensorsSemiconductor Science and Technology, 2010
- The study of the voltage drift in high-temperature proton conductor-based hydrogen sensors adopting the solid reference electrodeSensors and Actuators B: Chemical, 2009
- Sc-doped CaZrO3 hydrogen sensor for liquid blanket systemFusion Engineering and Design, 2008
- Solid-state potentiometric gas sensors—current status and future trendsJournal of Solid State Electrochemistry, 2008
- High‐Temperature Ceramic Gas Sensors: A ReviewInternational Journal of Applied Ceramic Technology, 2006
- Principles of solid state oxygen sensors for lean combustion gas controlElectrochimica Acta, 2001
- Trends in the development of solid state amperometric and potentiometric high temperature sensorsSolid State Ionics, 2000