Monitoring fatigue degradation in austenitic stainless steels
- 1 June 2004
- journal article
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 27 (7) , 595-607
Abstract
During cyclic loading of austenitic stainless steel, microstructural changes occurred, which affected both mechanical and physical properties. For certain steels, a strain‐induced martensitic phase transformation was observed. The investigations showed that for the given material and loading conditions the volume fraction of martensite depended on the cycle number, temperature and initial material state. It was found that the martensite content continuously increased with the cycle number. Therefore, the volume fraction of martensite was used for indication of the fatigue usage. The temperature dependence of the martensite formation was described by a Boltzmann function. The martensite content decreased with increasing temperature. Two different heats of the austenitic stainless steel X6CrNiTi18‐10 (AISI 321, DIN 1.4541) were investigated. The martensite formation rate was much higher for the cold‐worked material than for the solution‐annealed one. All applied techniques, neutron diffraction and advanced magnetic methods allowed the detection of martensite in the differently fatigued specimens.Keywords
This publication has 5 references indexed in Scilit:
- Monitoring of low-cycle fatigue degradation in X6CrNiTi18-10 austenitic steelJournal of Nuclear Materials, 2001
- Riesenmagnetowiderstand in magnetischen Schichtstrukturen: Werner Zinn in dankbarer Erinnerung gewidmetPhysikalische Blätter, 1995
- Plasticity-induced martensitic transformation during cyclic deformation of AISI 304L stainless steelMaterials Science and Engineering: A, 1989
- Influence of strain-induced martensitic transformation on the low-cycle fatigue behavior of a stainless steelMaterials Science and Engineering, 1977
- Kinetics of strain-induced martensitic nucleationMetallurgical Transactions A, 1975