D. Kalkhof
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
D. Kalkhof has a total of 3 co-authors. Here are the top co-authors by number of shared publications:
H. J. Leber
Paul Scherrer Institute, Nuclear Energy and Safety Department, CH-5232 Villigen PSI, Switzerland
1 shared publicationM. Grosse
Paul Scherrer Institute, Nuclear Energy and Safety Department, CH-5232 Villigen PSI, Switzerland
1 shared publication- Markus Niffenegger
Paul Scherrer Institute, Villigen, Switzerland
1 shared publication
Latest Publications
- 1 June 2004
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 27 (7) , 595-607
Monitoring fatigue degradation in austenitic stainless steels
During cyclic loading of austenitic stainless steel, microstructural changes occurred, which affected both mechanical and physical properties. For certain steels, a strain‐induced martensitic phase transformation was observed. The investigations showed that for the given material and loading conditions the volume fraction of martensite depended on the cycle number, temperature and initial material state. It was found that the martensite content continuously increased with the cycle number. Therefore, the volume fraction of martensite was used for indication of the fatigue usage. The temperature dependence of the martensite formation was described by a Boltzmann function. The martensite content decreased with increasing temperature. Two different heats of the austenitic stainless steel X6CrNiTi18‐10 (AISI 321, DIN 1.4541) were investigated. The martensite formation rate was much higher for the cold‐worked material than for the solution‐annealed one. All applied techniques, neutron diffraction and advanced magnetic methods allowed the detection of martensite in the differently fatigued specimens.
- 1 June 2004
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 27 (7) , 595-607
Monitoring fatigue degradation in austenitic stainless steels
During cyclic loading of austenitic stainless steel, microstructural changes occurred, which affected both mechanical and physical properties. For certain steels, a strain‐induced martensitic phase transformation was observed. The investigations showed that for the given material and loading conditions the volume fraction of martensite depended on the cycle number, temperature and initial material state. It was found that the martensite content continuously increased with the cycle number. Therefore, the volume fraction of martensite was used for indication of the fatigue usage. The temperature dependence of the martensite formation was described by a Boltzmann function. The martensite content decreased with increasing temperature. Two different heats of the austenitic stainless steel X6CrNiTi18‐10 (AISI 321, DIN 1.4541) were investigated. The martensite formation rate was much higher for the cold‐worked material than for the solution‐annealed one. All applied techniques, neutron diffraction and advanced magnetic methods allowed the detection of martensite in the differently fatigued specimens.