On the Use of the Heating Stage to Control the Thickness Distribution in Thermoformed Parts
- 1 May 2004
- journal article
- Published by Walter de Gruyter GmbH in International Polymer Processing
- Vol. 19 (2) , 186-198
Abstract
This work investigates the influence of the heating stage of roll-fed and sheet-to-sheet thermoforming on the thickness uniformity of the final parts produced. Modeling of the heat transfer process involved in each case is carried out. An inverse methodology capable of setting the temperature of the heaters that produce a prescribed sheet temperature at the end of the heating stage is presented. The sensitivity of this differential heating technique to moderate perturbations of the individual set values is analyzed.Keywords
This publication has 9 references indexed in Scilit:
- IR sheet heating in roll fed thermoforming: Part 1 - Solving direct and inverse heating problemsPlastics, Rubber and Composites: Macromolecular Engineering, 2002
- Three‐dimensional simulation of thermoforming process and its comparison with experimentsPolymer Engineering & Science, 2000
- Sensitivity of operating conditions and material properties for thermoforming processPlastics, Rubber and Composites: Macromolecular Engineering, 2000
- Wall thickness distribution in plug‐assist vacuum formed strawberry containersPolymer Engineering & Science, 1997
- Technology of Thermoforming1996
- Experimental and numerical investigations of the vacuum‐forming processPolymer Engineering & Science, 1992
- Computer simulation of thermoforming in complex shapesPolymer Engineering & Science, 1992
- Infrared radiation in the processing of plastics: Precise adjustment–the key to productivityAdvances in Polymer Technology, 1987
- Thickness variation in the thermoforming of poly(methyl methacrylate) and high‐impact polystyrene sheetsJournal of Applied Polymer Science, 1975