Characterization of galling during dry and lubricated punching of AA5754 sheet
Authors:
- Shayan ShirzadianSSShayan Shirzadian
- Sukanta BhowmickSBSukanta Bhowmick
- Ahmet T. AlpasAAAhmet T. Alpas
Open Access
- 1 November 2021
- journal article
- research article
- Published by Elsevier in Advances in Industrial and Manufacturing Engineering
- Vol. 3
Abstract
No abstract availableKeywords
Funding Information
- NSERC
This publication has 27 references indexed in Scilit:
- Application of hard coatings for blanking and piercing toolsWear, 2011
- Tribological testing of commercial CrN, (Ti,Al)N and CrC/C PVD coatings — Evaluation of galling and wear characteristics against different high strength steelsSurface and Coatings Technology, 2011
- Wear mechanisms in deep drawing of carbon steel – correlation to laboratory testingTribotest, 2008
- Evaluation of mechanical properties using shear–punch testingMaterials Science and Engineering: A, 2005
- Comparison between different test methods for evaluation of galling properties of surface engineered tool surfacesWear, 2004
- Galling initiation due to frictional heatingWear, 2003
- Adiabatic shear localization in the dynamic punch test, part I: experimental investigationInternational Journal of Plasticity, 1999
- Galling mechanisms in sheet forming operationsWear, 1994
- Dynamic recrystallization in high-strain, high-strain-rate plastic deformation of copperActa Metallurgica et Materialia, 1994
- New wear tests of tool materials for metal formingWear, 1984