Tribological characterization of Al6061/alumina/graphite/redmud hybrid composite for brake rotor application
- 29 January 2018
- journal article
- research article
- Published by Taylor & Francis in Particulate Science and Technology
- Vol. 37 (3) , 261-274
Abstract
Dry sliding tribological characterization of redmud particle-reinforced Al6061/alumina/graphite hybrid metal matrix composite (RM-AlHMMC) was investigated as per ASTM G99-05 using pin on disc experimental setup. Initially, hybrid composites were fabricated through stir casting process by varying the wt.% of redmud particle as 3, 7, and 11, and then the wear tests were carried out based on L27 orthogonal array. The experimental results revealed that 11 wt.% RM-AlHMMC showed maximum of 90% improved wear resistance than AlHMMC. For all the composites, the coefficient of friction (CoF) increases and saturates with the applied load and sliding distance, in which 11 wt.% RM-AlHMMC showed maximum of 48% increased CoF than AlHMMC. Metallographic investigation of worn-out AlHMMC composite showed that at maximum applied load, sliding velocity, and sliding distance, the wear mechanism changes from abrasive to adhesive, but adding of redmud particle showed combined adhesive and abrasive wear mechanisms. The optimized tribological parameters were obtained using grey relational analysis which revealed that 11 wt.% RM-AlHMMC has improved tribological properties.Keywords
This publication has 32 references indexed in Scilit:
- Surface Roughness Optimization in a Drilling Operation Using the Taguchi Design MethodMaterials and Manufacturing Processes, 2009
- Comparison of friction and wear performances of brake material dry sliding against two aluminum matrix composites reinforced with different SiC particlesJournal of Materials Processing Technology, 2007
- Wear behaviour of A356/25SiCp aluminium matrix composites sliding against automobile friction materialWear, 2006
- Abrasive wear of Al2O3 particle reinforced 2024 aluminium alloy composites fabricated by vortex methodComposites Part A: Applied Science and Manufacturing, 2006
- Wear and friction behavior of stir cast aluminium-base short steel fiber reinforced compositesWear, 2004
- Simulation of the stir casting processJournal of Materials Processing Technology, 2003
- Design of optimisation of cutting parameters for turning metal matrix composites based on the orthogonal arraysJournal of Materials Processing Technology, 2003
- Development of aluminum metal matrix composites (Al-MMC) brake rotor and padJSAE Review, 2002
- The role of tribo-layers on the sliding wear behavior of graphitic aluminum matrix compositesWear, 2001
- Dry sliding wear of aluminium composites—A reviewComposites Science and Technology, 1997