Improving element uniformity and mechanical properties of Al–Mg–Si alloy fabricated by twin roll casting with superheat melt treatment
Open Access
- 1 January 2022
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 9 (1) , 016516
Abstract
The effect of superheat melt treatment(SMT) on microstructure and properties of Al–Mg–Si alloy fabricated by twin roll casting(TRC) was analyzed using optical microscope, scanning electron microscopy, emission electron probe micro analyzer and transmission electron microscopy. SMT increased the subcooling degree of melt during TRC. The solidification microstructure with high dendrite density and small dendrite spacing was obtained. The second phase was evenly distributed between dendrites and the solute concentration gradient was decreased. Intergranular solute aggregation caused by Reynolds’ dilatancy in TRC slab was effectively suppressed. The homogeneous solute distribution of TRC slab with SMT can be realized by short-time homogenization heat treatment. The size of insoluble particles was greatly reduced. The complete decomposition of non-equilibrium eutectic phase increased the solute concentration in α-Al, which promoted the precipitation of precipitates during aging heat treatment. The tensile strength and yield strength of T6 slab were improved, while the uniform elongation are almost not decreased. The strength and uniform of slab in T4P state were both improved. The obtained results can help further shorten the production cycle of TRC slabs and improve mechanical properties.Keywords
Funding Information
- National Natural Science Foundation of China (51790485)
This publication has 33 references indexed in Scilit:
- The effect of mischmetal and heat treatment on the microstructure and tensile properties of A357 Al–Si casting alloyMaterials Science and Engineering: A, 2012
- Granular deformation mechanisms in semi-solid alloysActa Materialia, 2011
- Effect of melt superheat on microstructure of Al4Fe2Mn1.5 Monel alloyTransactions of Nonferrous Metals Society of China, 2009
- Phase stability and structural features of matrix-embedded hardening precipitates in Al–Mg–Si alloys in the early stages of evolutionActa Materialia, 2007
- A technique for characterizing microsegregation in multicomponent alloys and its application to single-crystal superalloy castingsMetallurgical and Materials Transactions A, 2005
- Effects of melt superheating treatment on microstructure of Mg2Si/Al–Si–Cu compositeJournal of Alloys and Compounds, 2005
- Precipitation strengthening of the aluminum alloy AA6111Metallurgical and Materials Transactions A, 2003
- On the precipitation-hardening behavior of the Al-Mg-Si-Cu alloy AA6111Metallurgical and Materials Transactions A, 2003
- Twin roll casting of aluminium alloysMaterials Science and Engineering: A, 2000
- Structure Determination of Mg 5 Si 6 Particles in Al by Dynamic Electron Diffraction StudiesScience, 1997