Millimeter-wave BiST and BiSC using a high-definition sub-ranged detector in 90nm CMOS
- 1 August 2010
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 477-480
Abstract
A wideband CMOS mm-Wave amplitude detector for on-chip self-test and calibration is presented. The high-conversion-gain detector enables accurate on-chip amplitude measurements and allows for the prediction of key RF parameters. The detector operates across the 60 GHz band and achieves a dynamic range of 0-0.5 V and a sensitivity of -9 V/V. The detector's practical use in mm-wave Built-in-Self-Test (BiST) and Built-in-Self-Calibration (BiSC) circuits is demonstrated using a 60 GHz CMOS LNA. Simulation results show that the LNA gain, compression point, and intermodulation distortion are predicted with minimal error. The detector and LNA are built in IBM's 90 nm CMOS technology.Keywords
This publication has 11 references indexed in Scilit:
- Transceiver parameter detection using a high conversion gain RF amplitude detector2010
- Input match and load tank digital calibration of an inductively degenerated CMOS LNAIntegration, 2009
- A Broadband CMOS Amplitude Detector for On-Chip RF MeasurementsIEEE Transactions on Instrumentation and Measurement, 2008
- A Build-in Self-Test Technique for RF Low-Noise AmplifiersIEEE Transactions on Microwave Theory and Techniques, 2008
- Low Cost RF Receiver Parameter Measurement with On-Chip Amplitude Detectors2008
- A Current Injection Built-In Test Technique for RF Low-Noise AmplifiersIEEE Transactions on Circuits and Systems I: Regular Papers, 2008
- RF Front-end System Gain and Linearity Built-in Test2006
- Integrated CMOS Power Sensors for RF BIST Applications2006
- A CMOS RF RMS Detector for Built-in Testing of Wireless Transceivers2005
- Using the weak inversion region to optimize input stage design of CMOS op ampsIEEE Transactions on Circuits and Systems II: Express Briefs, 2004