Reduced recombination in a surface-sulfurized Cu(InGa)Se 2 thin-film solar cell
- 29 March 2018
- journal article
- research article
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 57 (5)
Abstract
This study demonstrates surface sulfurization effects on Cu(InGa)Se 2 (CIGSe) thin-film solar cells with a single back-graded band gap. Single back-graded CIGSe thin films were prepared via a three-stage process in a high-vacuum molecular beam epitaxial growth chamber and were subsequently annealed in a tube furnace under environmental conditions with H 2 S gas. After sulfurization, an ∼80- to ∼100-nm-thick CuIn(SSe) 2 layer with significantly small Ga contents (CISSe:Ga) was formed on the CIGSe layer. The newly formed CISSe:Ga layer exhibited graded S contents from surface to bulk, thus resulting in a front-graded band gap. In addition, CISSe:Ga was covered with S-enriched CISSe region that was extended from the surface to a depth of a few nm and was depleted of Ga. A device with the sulfurized CIGSe showed reduced recombination at the buffer–absorber interface, in space-charge region and in bulk. Consequently, the open circuit voltage increased from 0.58 V (in the non-sulfurized case) to 0.66 V, and the conversion efficiency improved from 15.5 to 19.4%. This large improvement is caused by the front graded band gap at the surface and the hole-blocking barrier, which suppress recombination at the CdS/CISSe:Ga interface. In addition, sulfurization followed by KF post-deposition treatment (PDT) increased the efficiency to 20.1%. Compared to the untreated sulfurized device, the KF-PDT device delivered an increased carrier lifetime and reduced the recombination in bulk probably because the defects were passivated by the K, which penetrated into the bulk region.Keywords
This publication has 22 references indexed in Scilit:
- Reformulation of solar cell physics to facilitate experimental separation of recombination pathwaysApplied Physics Letters, 2013
- Invited Paper: CIGS-based thin film solar cells and modules: Unique material propertiesElectronic Materials Letters, 2012
- The path towards a high-performance solution-processed kesterite solar cellSolar Energy Materials and Solar Cells, 2011
- Thin‐film solar cells: device measurements and analysisProgress in Photovoltaics: Research and Applications, 2004
- High‐efficiency copper indium gallium diselenide (CIGS) solar cells with indium sulfide buffer layers deposited by atomic layer chemical vapor deposition (ALCVD)Progress in Photovoltaics: Research and Applications, 2003
- Improved CIGS thin-film solar cells by surface sulfurization using In2S3 and sulfur vaporSolar Energy Materials and Solar Cells, 2001
- Role of incorporated sulfur into the surface of Cu(InGa)Se2 thin-film absorberSolar Energy Materials and Solar Cells, 2001
- Improved Cu(In,Ga)(S,Se)2 thin film solar cells by surface sulfurizationSolar Energy Materials and Solar Cells, 1997
- Accuracy of analytical expressions for solar cell fill factorsSolar Cells, 1982
- Electron and X-ray diffraction analyses of ternary compound (I–III–VI2) thin filmsThin Solid Films, 1976