Self-Oscillating Joule Thief Converters for MEMS Electromagnetic Energy Harvesting: Analytical Modeling and Experimental Validation
- 13 March 2026
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 73 (8) , 11551-11563
Abstract
MEMS electromagnetic energy harvesters face a critical cold-start bottleneck: ultralow voltage combined with high source impedance. Existing startup converters optimize for either low voltage or high impedance, rarely both. This article addresses this challenge by adapting the self-oscillating joule thief topology through closed-form analytical modeling. Unlike prior semianalytical approaches requiring iterative simulation, our framework enables simulation-free design exploration of bipolar junction transistor (BJT)- and N-type metal-oxide-semiconductor (NMOS)-based implementations. For both implementations, the analytical model predicts output voltage within 10% of experimental results over the measured voltage, load, and source-resistance sweeps. The NMOS version demonstrates a 50 mV start-up from a 300 $\boldsymbol{\Omega}$ source impedance. Experimental validation with a 300 $\boldsymbol{\Omega}$ electromagnetic energy harvester shows a tradeoff in practice: zero-threshold NMOS starts at 0.35 g rms acceleration but provides 43% boost; low-threshold NMOS starts at 0.5 g but achieves 93% boost—both outperforming TI BQ25570’s 0.7 g startup requirement. By positioning the joule thief as a specialized startup circuit complementing high-efficiency main converters, this framework addresses a key barrier to self-powered MEMS deployment and high-impedance source energy harvesting.Keywords
Funding Information
- Norges Forskningsråd (299279)
This publication has 26 references indexed in Scilit:
- Enhanced power supply circuitry with long duration and high‐efficiency charging for indoor photovoltaic energy harvesting internet of things end deviceIET Power Electronics, 2024
- Design architectures for energy harvesting in the Internet of ThingsRenewable and Sustainable Energy Reviews, 2020
- A Silicon MEMS EM vibration energy harvesterJournal of Physics: Conference Series, 2019
- Blocking oscillator-based electronic circuit to harvest and boost the voltage produced by a compost-based microbial fuel cell stackSustainable Energy Technologies and Assessments, 2018
- Optimized Electromagnetic Harvester with a Non-Magnetic Inertial MassProcedia Engineering, 2015
- CMOS Circuits for Electromagnetic Vibration Transducers2015
- A novel low-drop CMOS active rectifier for RF-powered devices: Experimental resultsMicroelectronics Journal, 2009
- Design and implementation of mechanical resonators for optimized inertial electromagnetic microgeneratorsMicrosystem Technologies, 2007
- A micro electromagnetic generator for vibration energy harvestingJournal of Micromechanics and Microengineering, 2007
- Analysis and Design of a Transistor Blocking Oscillator Including Inherent NonlinearitiesBell System Technical Journal, 1959