A review of microstructure and mechanical properties of additively manufactured aluminum alloys
Authors:
- Olga ZinovievaOZOlga Zinovieva
- Varvara RomanovaVRVarvara Romanova
- Ruslan BalokhonovRBRuslan Balokhonov
- Tatiana EmelyanovaTETatiana Emelyanova
- 14 December 2020
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2310 (1) , 020364
Abstract
The ever-increasing demand for lightweight complex-shaped components is the key driver for additive manufacturing of aluminum alloy parts. Due to extreme process conditions, additively manufactured aluminum alloys are characterized by specific microstructures and thus mechanical properties different from those observed in conventionally manufactured alloys of similar composition. This paper discusses the current research status of microstructure and mechanical properties of aluminum alloys produced by selective laser melting, focusing on Al-Si alloys.Keywords
This publication has 24 references indexed in Scilit:
- Porosity Inducing Process Parameters in Selective Laser Melted AlSi10Mg Aluminium AlloyPhysical Mesomechanics, 2020
- A review of selective laser melting of aluminum alloys: Processing, microstructure, property and developing trendsJournal of Materials Science & Technology, 2019
- Microstructure evolution and thermal properties of an additively manufactured, solution treatable AlSi10Mg partJournal of Materials Research, 2018
- Influence of scan strategy and molten pool configuration on microstructures and tensile properties of selective laser melting additive manufactured aluminum based partsOptics & Laser Technology, 2018
- Microstructure and mechanical property considerations in additive manufacturing of aluminum alloysMRS Bulletin, 2016
- Simultaneous enhancements of strength and toughness in an Al-12Si alloy synthesized using selective laser meltingActa Materialia, 2016
- Selective laser melting of high strength Al–Cu–Mg alloys: Processing, microstructure and mechanical propertiesMaterials Science and Engineering: A, 2016
- Precipitation behavior of aluminum alloy 2139 fabricated using additive manufacturingMaterials Science and Engineering: A, 2015
- Microstructure and mechanical properties of Al–12Si produced by selective laser melting: Effect of heat treatmentMaterials Science and Engineering: A, 2014
- Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powderActa Materialia, 2013