Photonic Flash Soldering of Thin Chips and SMD Components on Foils for Flexible Electronics
- 14 October 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 4 (11) , 1879-1886
Abstract
Ultrathin bare die chips and small-size surface mount device components were successfully soldered using a novel roll-to-roll compatible soldering technology. A high-power xenon light flash was used to successfully solder the components to copper tracks on polyimide (PI) and polyethylene terephthalate (PET) flex foils by using a lead-free solder paste. Results are compared with oven-reflowed solder joints on PI substrates. The delicate PET foil substrates were not damaged owing to the selectivity of light absorption, leading to a limited temperature increase in the PET foil while the chip and copper tracks were heated to a temperature high enough to initiate soldering. The microstructure of the soldered joints was investigated and found to be dependent on the photonic flash intensity. Reliability of the photonically soldered joints during damp heat testing and dynamic flexing testing was comparable with the reflowed benchmark and showed increased reliability compared with anisotropic conductive adhesives bonded on PET foils.Keywords
Funding Information
- NanonextNL Project entitled Integration Technologies for Flexible Systems (10A.03)
- Holst Centre, Eindhoven, The Netherlands, within the Program entitled Heterogeneous Sensor Systems on Foil
This publication has 21 references indexed in Scilit:
- Photonic flash sintering of silver nanoparticle inks: a fast and convenient method for the preparation of highly conductive structures on foilMRS Communications, 2012
- Novel interconnect methodologies for ultra-thin chips on foils2012
- Roll‐to‐Roll Compatible Sintering of Inkjet Printed Features by Photonic and Microwave Exposure: From Non‐Conductive Ink to 40% Bulk Silver Conductivity in Less Than 15 SecondsAdvanced Materials, 2012
- Photonic Sintering of Silver Nanoparticles: Comparison of Experiment and Theory2012
- Pseudo-CMOS: A Design Style for Low-Cost and Robust Flexible ElectronicsIEEE Transactions on Electron Devices, 2010
- Fabrication Processes for Embedding Thin Chips in Flat Flexible SubstratesIEEE Transactions on Advanced Packaging, 2009
- Self-consistent optical parameters of intrinsic silicon at 300K including temperature coefficientsSolar Energy Materials and Solar Cells, 2008
- 01005 SMT component assembly for wireless SIP modules2005
- Microstructure evolution of eutectic Sn-Ag solder jointsJournal of Electronic Materials, 1994
- Fluence-dependent transmission of polyimide at 248 nm under laser ablation conditionsApplied Physics Letters, 1991