Investigation of Flow and Heat Transfer of an Impinging Jet in a Cross-Flow For Cooling of a Heated Cube
Authors:
- 30 November 2005
- journal article
- Published by ASME International in Journal of Electronic Packaging
- Vol. 128 (2) , 150-156
Abstract
The current trends toward the greater functionality of electronic devices are resulting in a steady increase in the amount of heat dissipated from electronic components. Forced channel flow is frequently used to remove heat at the walls of the channel where a PCB with a few high heat dissipating components is located. The overall cooling strategy thus must not only match the overall power dissipation load, but also address the requirements of the “hot” components. In order to cool the thermal load with forced channel flow, excessive flow rates will be required. The objective of this study is to investigate if targeted cooling systems, i.e., an impinging jet in combination with a low velocity channel flow, can improve the thermal performance of the system. The steady-state three-dimensional (3-D) model is developed with the Reynolds-Stress-Model (RSM) as a turbulence model. The geometrical case is a channel with a heated cube in the middle of the base plate and two inlets, one horizontal channel flow, and one vertical impinging jet. The numerical model is validated against experimental data obtained from three well-known cases, two cases with an impinging jet on a flat heated plate, and one case with a heated cube in a single channel flow. The effects of the jet Re and jet to-cross-flow velocity ratio are investigated. The airflow pattern around the cube and the surface temperature of the cube as well as the mean values and local distributions of the heat transfer coefficient are presented.Keywords
This publication has 6 references indexed in Scilit:
- Turbulent heat transfer from a multi-layered wall-mounted cube matrix: a large eddy simulationInternational Journal of Heat and Fluid Flow, 2002
- Experimental study of the convective heat transfer from in-line and staggered configurations of two wall-mounted cubesInternational Journal of Heat and Mass Transfer, 2002
- Vortex structure and heat transfer in turbulent flow over a wall-mounted matrix of cubesInternational Journal of Heat and Fluid Flow, 1999
- STAGNATION REGION HEAT TRANSFER OF A TURBULENT AXISYMMETRIC JET IMPINGEMENTExperimental Heat Transfer, 1999
- Numerical study of turbulent heat transfer in confined and unconfined impinging jetsInternational Journal of Heat and Fluid Flow, 1999
- Air jet impingement heat transfer at low nozzle-plate spacingsInternational Journal of Heat and Mass Transfer, 1994