DRD. Rundström

D. Rundström

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


D. Rundström has a total of 2 co-authors. Here are the top co-authors by number of shared publications:

  • B. Moshfegh

    Division of Energy and Mechanical Engineering, Department of Technology and Build Environment University of Gävle Gävle, Sweden and Department of Mechanical Engineering, Linköping University, Linköping, Sweden

    1 shared publication
  • B. Moshfegh

    Division of Energy and Mechanical Engineering, Department of Technology and Build Environment, University of Gävle, 801 76 Gävle, Sweden; Department of Mechanical Engineering, Linköping University, Linköping, Sweden

    1 shared publication

Latest Publications

  • Investigation of Heat Transfer and Pressure Drop of an Impinging Jet in a Cross-Flow for Cooling of a Heated Cube

    by D. Rundström, B. Moshfegh

    The objective of this study is to investigate the thermal performance and the cost measured in pressure drops of a targeted cooling system with use of an impinging jet in combination with a low-velocity channel flow on a heated wall-mounted cube. The effects of the Reynolds numbers of the impinging jet and the cross-flow, as well as the distance between the top and bottom plates, are investigated. A steady-state 3D computational fluid dynamics model was developed with use of a Reynolds stress model as turbulence model. The geometrical case is a channel with a heated cube in the middle of the base plate and two inlets, one horizontal channel flow and one vertical impinging jet. The numerical model was validated against experimental data with a similar geometrical setup. The velocity field was measured by particle image velocimetry and the surface temperature was measured by an infrared imaging system. This case results in a very complex flow structure where several flow-related phenomena influence the heat transfer rate and the pressure drops. The average heat transfer coefficients on each side of the cube and the pressure loss coefficients are presented; correlations for the average heat transfer coefficient on the cube and the pressure loss coefficients are created.


  • Investigation of Flow and Heat Transfer of an Impinging Jet in a Cross-Flow For Cooling of a Heated Cube

    by D. Rundström, B. Moshfegh

    The current trends toward the greater functionality of electronic devices are resulting in a steady increase in the amount of heat dissipated from electronic components. Forced channel flow is frequently used to remove heat at the walls of the channel where a PCB with a few high heat dissipating components is located. The overall cooling strategy thus must not only match the overall power dissipation load, but also address the requirements of the “hot” components. In order to cool the thermal load with forced channel flow, excessive flow rates will be required. The objective of this study is to investigate if targeted cooling systems, i.e., an impinging jet in combination with a low velocity channel flow, can improve the thermal performance of the system. The steady-state three-dimensional (3-D) model is developed with the Reynolds-Stress-Model (RSM) as a turbulence model. The geometrical case is a channel with a heated cube in the middle of the base plate and two inlets, one horizontal channel flow, and one vertical impinging jet. The numerical model is validated against experimental data obtained from three well-known cases, two cases with an impinging jet on a flat heated plate, and one case with a heated cube in a single channel flow. The effects of the jet Re and jet to-cross-flow velocity ratio are investigated. The airflow pattern around the cube and the surface temperature of the cube as well as the mean values and local distributions of the heat transfer coefficient are presented.