Hot Compression Deformation Behavior and Microstructure of As-Cast and Homogenized AA2195 Al-Li Alloy
Open Access
Abstract
To understand the effect of the initial state of AA2195 Al-Li alloy on the forming process, as-cast and homogenized ingots were compressed by using a Gleeble-3150 thermo-mechanical simulator at different temperatures (360–480 °C) and strain rates (0.01–10 s−1). The hot compression deformation behaviors and microstructural characteristics of the two types of ingots were systematically investigated. The as-cast alloy possessed a better hot compressibility with higher power dissipation efficiency and lower rheological stress than the homogenized alloy under the same deformation conditions. When the temperature was increased above 450 °C, all the alloys showed similar rheological curves. Based on the rheological stress curves, processing maps for the as-cast (AC) and homogenized (HG) alloys were established, and optimal processing domains were identified. In addition, the homogenized alloys were dominated by a fibrous microstructure during deformation, whereas the as-cast alloy produced fine crystals at low temperature (360 °C) and equiaxed crystals at high temperature (480 °C). Our results show that it is possible to use the as-cast 2195 Al-Li alloy as the initial billet to get complicated components. This is attributed to the dispersed eutectic phases, which can provide more nucleation sites for Dynamic Recrystallization (DRX) and Dynamic Recovery (DRV) during hot deformation.Keywords
Funding Information
- National Key R&D Program of China (2020YFA0711104, U21B6004)
- National Natural Science Foundation of China (2020YFA0711104, U21B6004)
This publication has 31 references indexed in Scilit:
- Aerostructural Design and Its Application to Aluminum–Lithium Alloys2014
- Hot deformation and processing map of a typical Al–Zn–Mg–Cu alloyJournal of Alloys and Compounds, 2013
- A study of the heterogeneity of plastic deformation in IF steel by EBSDMaterials Science and Engineering: A, 2012
- The deformation behavior and processing maps in the isothermal compression of 7A09 aluminum alloyMaterials Science and Engineering: A, 2012
- Identification for the optimal working parameters of Al–Zn–Mg–Cu alloy with the processing maps based on DMMThe International Journal of Advanced Manufacturing Technology, 2011
- Orientation gradients and geometrically necessary dislocations in ultrafine grained dual-phase steels studied by 2D and 3D EBSDMaterials Science and Engineering: A, 2010
- Flow behavior and microstructural evolution of Al–Cu–Mg–Ag alloy during hot compression deformationMaterials Science and Engineering: A, 2009
- Manufacturing of Lightweight Components by Metal FormingCIRP Annals, 2003
- The Effects of Artificial Aging on the Microstructure and Fracture Toughness of Al-Cu-Li Alloy 2195Journal of Materials Engineering and Performance, 1998
- Processing maps for hot working of titanium alloysMaterials Science and Engineering: A, 1998