DSDongfeng Shi

Dongfeng Shi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Dongfeng Shi has a total of 2 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Hot Compression Deformation Behavior and Microstructure of As-Cast and Homogenized AA2195 Al-Li Alloy

    by Jin Zhang, Zemeng Liu, Dongfeng Shi

    To understand the effect of the initial state of AA2195 Al-Li alloy on the forming process, as-cast and homogenized ingots were compressed by using a Gleeble-3150 thermo-mechanical simulator at different temperatures (360–480 °C) and strain rates (0.01–10 s−1). The hot compression deformation behaviors and microstructural characteristics of the two types of ingots were systematically investigated. The as-cast alloy possessed a better hot compressibility with higher power dissipation efficiency and lower rheological stress than the homogenized alloy under the same deformation conditions. When the temperature was increased above 450 °C, all the alloys showed similar rheological curves. Based on the rheological stress curves, processing maps for the as-cast (AC) and homogenized (HG) alloys were established, and optimal processing domains were identified. In addition, the homogenized alloys were dominated by a fibrous microstructure during deformation, whereas the as-cast alloy produced fine crystals at low temperature (360 °C) and equiaxed crystals at high temperature (480 °C). Our results show that it is possible to use the as-cast 2195 Al-Li alloy as the initial billet to get complicated components. This is attributed to the dispersed eutectic phases, which can provide more nucleation sites for Dynamic Recrystallization (DRX) and Dynamic Recovery (DRV) during hot deformation.


  • Open Access

    Abnormal Twinning Behavior Induced by Local Stress in Magnesium

    by Dongfeng Shi, Jin Zhang

    This study investigated the twinning behavior with increasing compressive strain in rolled AZ31 alloy. With that purpose, a polycrystalline structure with an average grain size of 30 μm was utilized to perform the uniaxial compression tests. Microstructure evolution was traced by in situ electron backscattered diffraction (EBSD). Multiple primary twin variants and extension double twins were observed in the same grain. A comprehensive analysis of kernel average misorientation (KAM) and Schmid factor (SF) revealed that the nucleation of twins in one special grain is not only based on the SF criterion, but that it is also strongly influenced by surrounding grains. Moreover, the existing primary twins modified the inner and outer strain distribution close to the twin boundaries. With continued compression, the strain inside the primary twins stimulated the nucleation of double twins, while the strain in the matrixes facilitated twin growth. Therefore, the primary twin growth and the new nucleation of secondary twins could take place simultaneously in the same twinning system to meet the requirements of strain accommodation. Twinning behaviors are controlled by the combined effect of the Schmid factor, strain accommodation between surrounding grains, and variation in the local stress state. The local stress exceeded the critical resolved shear stress (CRSS), implying that twin nucleation is possible. Hence, the twinning process tends to be a response of the local stress rather than the applied stress.