Results of Investigation of Multicell Converters With Balancing Circuit—Part I
Authors:
- Robert StalaRSRobert Stala
- Stanislaw PirogSPStanislaw Pirog
- Marcin BaszynskiMBMarcin Baszynski
- Andrzej MondzikAMAndrzej Mondzik
- Adam PenczekAPAdam Penczek
- Jaroslaw CzekonskiJCJaroslaw Czekonski
- Stanislaw GasiorekSGStanislaw Gasiorek
- 12 May 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 56 (7) , 2610-2619
Abstract
This paper presents the results of an investigation of the multilevel multicell converters with a passive RLC balancing circuit applied for the maintenance of the voltage sharing on the capacitive sources of the converters. The topologies of DC/DC, AC/AC, DC/AC, and AC/DC multicell converters were analyzed. For the purpose of multilevel modulation, a multicell converter employs several capacitors that are connected to every cell-the flying capacitors, charged to a given level of voltage. An inadequate relation between the voltages across the flying capacitors (the unbalance state) results in the increase of the voltages above their rated values across the switches. An RLC series circuit (a balancing circuit) with the properly selected resonance frequency is connected in parallel to the load in order to eliminate the unbalance. The balancing process with the use of passive RLC depends on the configuration and parameters of the balancing circuit, the parameters of the converter, as well as on the operating conditions. This paper presents the mathematical description of both the converter and the balancing process, the balancing circuit approach in the different topologies of the multicell converters, a selection of the balancing circuit parameters, and the analysis of the improper control conditions.Keywords
This publication has 31 references indexed in Scilit:
- Feed-Forward Space Vector Modulation for Single-Phase Multilevel Cascaded Converters With Any DC Voltage RatioIEEE Transactions on Industrial Electronics, 2008
- Model Predictive Control of an Asymmetric Flying Capacitor ConverterIEEE Transactions on Industrial Electronics, 2008
- Capacitor Balance Issues of the Diode-Clamped Multilevel Inverter Operated in a Quasi Two-State ModeIEEE Transactions on Industrial Electronics, 2008
- A Predictive Control With Flying Capacitor Balancing of a Multicell Active Power FilterIEEE Transactions on Industrial Electronics, 2008
- Closed-Loop Control of a Three-Phase Neutral-Point-Clamped Inverter Using an Optimized Virtual-Vector-Based Pulsewidth ModulationIEEE Transactions on Industrial Electronics, 2008
- Capacitor voltage balancing in multilevel flying capacitor inverters by rule-based switching pattern selectionIET Electric Power Applications, 2007
- A Symmetric Carrier Technique of CRPWM for Voltage Balance Method of Flying-Capacitor Multilevel InverterIEEE Transactions on Industrial Electronics, 2005
- Using the Multilevel Imbricated Cells Topologies in the Design of Low-Power Power-Factor-Corrector ConvertersIEEE Transactions on Industrial Electronics, 2005
- Flying capacitor multilevel inverters and DTC motor drive applicationsIEEE Transactions on Industrial Electronics, 2002
- Self-balancing of the clamping-capacitor-voltages in the multilevel capacitor-clamping-inverter under sub-harmonic PWM modulationIEEE Transactions on Power Electronics, 2001