ATCA Control System Hardware for the Plasma Vertical Stabilization in the JET Tokamak
Authors:
- 12 April 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 57 (2) , 583-588
Abstract
A multi-input-multi-output controller for the plasma vertical stabilization was implemented and installed on the Joint European Torus tokamak. The system can attain a control-cycle time of approximately 30 ¿s using ×86 multi-core processors but targets 10 ¿s via Field Programmable Gate Array (FPGA) based processing. The hardware, complying with the Advanced Telecommunications Computing Architecture (ATCA) standard, was in-house designed and implemented to achieve the required performance and consists of: A total of 6 synchronized ATCA control boards, each one with 32 analog input channels which provide up to 192 galvanically-isolated channels, used mainly for magnetic measurements. Each board contains an FPGA, which performs digital signal processing and includes a PCI Express communications interface; An ATCA rear transition module, which comprises up to 8 galvanically-isolated analog output channels to control the fast radial field amplifier (±10 kV, ±2.5 kA). An optical link to digitally control the enhanced radial field amplifier (±12 kV, ±5 kA). Up to 8 EIA-485 digital inputs for timing and monitoring information; An ATCA processor blade with a quad-core processor, where the control algorithm is presently running, connected to the 6 ATCA control boards through the PCI Express interface. All FPGAs are interconnected by low-latency links via the ATCA full-mesh backplane, allowing all channel data to be available on each FPGA running an upcoming distributed control algorithm.Keywords
This publication has 7 references indexed in Scilit:
- Overview of JET resultsNuclear Fusion, 2009
- The design and manufacture of the enhanced radial field amplifier (ERFA) for the jet projectFusion Engineering and Design, 2009
- Plasma control systems relevant to ITER and fusion power plantsFusion Engineering and Design, 2008
- The JET PCU project: An international plasma control projectFusion Engineering and Design, 2008
- ATCA digital controller hardware for vertical stabilization of plasmas in tokamaksReview of Scientific Instruments, 2006
- Analysis and specification of the performances of the new JET amplifier for the vertical stabilisation2002
- Plasma modelling for the control of vertical instabilities in tokamaksNuclear Fusion, 1989