Abrasive wear of high velocity oxygen fuel (HVOF) superalloy coatings under vibration load
Open Access
- 28 February 2017
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 174 (1) , 012010
Abstract
The present paper considers wear of coatings deposited by HVOF (High velocity oxy-fuel) technology, under conditions of dry friction against abrasive surface accompanied with the action of vibrations perpendicular to the sliding axis. Results are obtained with four type coatings: two types with Ni matrix of composition 602P – without preliminary heating of the basic surface (the substrate) and after substrate heating up to 650°C in a chamber; coating WC-12Co with tungsten matrix and coating obtained by 1:1 proportion powder mixture of both compositions 602P and WC-12Co. Results about the thickness, hardness and coating' morphology are presented, as well as dependences of the wear and the relative wear resistance on vibration speeds in the interval 3.03 to 21.08 mm/s. New results are obtained about the nonlinear relationship between abrasive wear and vibration speed showing minimal wear for all specimens by 6.04 mm/s. It is found that lowest wear shows WC-12Co coating in the entire interval of vibration speed variation: 3.03 to 21.08 mm/s. The obtained results are new in the literature; they are not presented and published by the authors.Keywords
This publication has 11 references indexed in Scilit:
- Abrasive wear of high velocity oxygen fuel (HVOF) superalloy coatings under vibration loadIOP Conference Series: Materials Science and Engineering, 2017
- Parameter Studies on High-Velocity Oxy-Fuel Spraying of CoNiCrAlY Coatings Used in the Aeronautical IndustryInternational Journal of Corrosion, 2014
- Handbook of Friction-Vibration Interactions2014
- Influence of plasma spraying parameters on properties of thermal barrier coatingsMaterials Science and Technology, 2013
- Tribology of Thermal-Sprayed Coatings2013
- Optimization and Characterization of High Velocity Oxy-fuel Sprayed Coatings: Techniques, Materials, and ApplicationsCoatings, 2011
- Possibility of the Abrasive Wear Resistance Determination with Scratch TesterTribology Letters, 2009
- Effect of Powder Characteristics on Properties of Warm-Sprayed WC-Co CoatingsJournal of Thermal Spray Technology, 2009
- The Science and Engineering of Thermal Spray Coatings2008
- Comparison of HVOF and plasma-sprayed alumina/titania coatings—microstructure, mechanical properties and abrasion behaviorSurface and Coatings Technology, 2003