Dimitar Karastoyanov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dimitar Karastoyanov has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
- Lyubka Doukovska
Intelligent Systems Department, Institute of Information and Communication Technologies, Bulgarian Academy of Sciences, 1113 Sofia, Bulgaria
4 shared publications - Mara Kandeva
Faculty of Industrial Technology, Technical University of Sofia, Bulgaria
3 shared publications - Nikolay Stoimenov
Bulgarian Academy of Sciences
3 shared publications Todor Penchev
Technical University of Sofia; bl. 8, Kl. Ochridski str., 1000, Bulgaria
3 shared publications- Aleksandar Vencl
University of Belgrade, Faculty of Mechanical Engineering, Kraljice Marije 16, 11120 Belgrade, Serbia
2 shared publications Alessandra Setti
Università di Pavia
2 shared publications
Latest Publications
- 19 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 150-152
Prevention of Transmission of Infections in Robotic Milking
The article examines the risks of infections in the robotic milking of cows. Various infection protection devices are presented. An innovative Device for preventing the transmission of infections in robotic milking through a barrier in the milk container is described. The advantages and disadvantages of such devices are discussed.
- 19 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 150-152
Prevention of Transmission of Infections in Robotic Milking
The article examines the risks of infections in the robotic milking of cows. Various infection protection devices are presented. An innovative Device for preventing the transmission of infections in robotic milking through a barrier in the milk container is described. The advantages and disadvantages of such devices are discussed.
- 1 March 2023
- Published by IATED Academy in INTED Proceedings
- Vol. 1, 1856-1863
ICT FOR RESEARCH AND EDUCATION OF VISUALLY IMPAIRED PEOPLE
- 1 March 2023
- Published by IATED Academy in INTED Proceedings
- Vol. 1, 1856-1863
ICT FOR RESEARCH AND EDUCATION OF VISUALLY IMPAIRED PEOPLE
- 26 June 2018
- Published by Springer Nature
- p. 237-245
Exploiting a Graphical Braille Display for Art Masterpieces
- 26 June 2018
- Published by Springer Nature
- p. 237-245
Exploiting a Graphical Braille Display for Art Masterpieces
- 26 June 2018
- Published by Springer Nature
- p. 267-274
Art Masterpieces Accessibility for Blind and Visually Impaired People
- 26 June 2018
- Published by Springer Nature
- p. 267-274
Art Masterpieces Accessibility for Blind and Visually Impaired People
- Open Access
- 1 June 2017
- Published by Faculty of Engineering, University of Kragujevac in Tribology in Industry
- Vol. 39 (2) , 228-237
Tribological studies on copper-based friction linings
- 1 June 2017
- Published by Faculty of Engineering, University of Kragujevac in Tribology in Industry
- Vol. 39 (2) , 228-237
Open AccessTribological studies on copper-based friction linings
- Open Access
- 28 February 2017
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 174 (1) , 012010
Abrasive wear of high velocity oxygen fuel (HVOF) superalloy coatings under vibration load
The present paper considers wear of coatings deposited by HVOF (High velocity oxy-fuel) technology, under conditions of dry friction against abrasive surface accompanied with the action of vibrations perpendicular to the sliding axis. Results are obtained with four type coatings: two types with Ni matrix of composition 602P – without preliminary heating of the basic surface (the substrate) and after substrate heating up to 650°C in a chamber; coating WC-12Co with tungsten matrix and coating obtained by 1:1 proportion powder mixture of both compositions 602P and WC-12Co. Results about the thickness, hardness and coating' morphology are presented, as well as dependences of the wear and the relative wear resistance on vibration speeds in the interval 3.03 to 21.08 mm/s. New results are obtained about the nonlinear relationship between abrasive wear and vibration speed showing minimal wear for all specimens by 6.04 mm/s. It is found that lowest wear shows WC-12Co coating in the entire interval of vibration speed variation: 3.03 to 21.08 mm/s. The obtained results are new in the literature; they are not presented and published by the authors.
- 28 February 2017
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 174 (1) , 012010
Open AccessAbrasive wear of high velocity oxygen fuel (HVOF) superalloy coatings under vibration load
The present paper considers wear of coatings deposited by HVOF (High velocity oxy-fuel) technology, under conditions of dry friction against abrasive surface accompanied with the action of vibrations perpendicular to the sliding axis. Results are obtained with four type coatings: two types with Ni matrix of composition 602P – without preliminary heating of the basic surface (the substrate) and after substrate heating up to 650°C in a chamber; coating WC-12Co with tungsten matrix and coating obtained by 1:1 proportion powder mixture of both compositions 602P and WC-12Co. Results about the thickness, hardness and coating' morphology are presented, as well as dependences of the wear and the relative wear resistance on vibration speeds in the interval 3.03 to 21.08 mm/s. New results are obtained about the nonlinear relationship between abrasive wear and vibration speed showing minimal wear for all specimens by 6.04 mm/s. It is found that lowest wear shows WC-12Co coating in the entire interval of vibration speed variation: 3.03 to 21.08 mm/s. The obtained results are new in the literature; they are not presented and published by the authors.
- Open Access
- 28 February 2017
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 174 (1) , 012060
Wear resistance of WC/Co HVOF-coatings and galvanic Cr coatings modified by diamond nanoparticles
The efforts in the recent 20 years are related to search of ecological solutions in the tribotechnologies for the replacement of galvanic Cr coatings in the contact systems operating under extreme conditions: abrasion, erosion, cavitation, corrosion, shock and vibration loads. One of the solutions is in the composite coatings deposited by high velocity gas-flame process (HVOF). The present paper presents comparative study results for mechanical and tribological characteristics of galvanic Cr coatings without nanoparticles, galvanic Cr coatings modified by diamond nanoparticles NDDS of various concentration 0.6; 10; 15 и 20% obtained under three technological regimes, and composite WC-12Co coating. Comparative results about hardness, wear, wear resistance and friction coefficient are obtained for galvanic Cr-NDDS and WC-12Co coatings operating at equal friction conditions of dry friction on abrasive surface. The WC-12Co coating shows 5.4 to 7 times higher wear resistance compared to the galvanic Cr-NDDS coatings.
- 28 February 2017
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 174 (1) , 012060
Open AccessWear resistance of WC/Co HVOF-coatings and galvanic Cr coatings modified by diamond nanoparticles
The efforts in the recent 20 years are related to search of ecological solutions in the tribotechnologies for the replacement of galvanic Cr coatings in the contact systems operating under extreme conditions: abrasion, erosion, cavitation, corrosion, shock and vibration loads. One of the solutions is in the composite coatings deposited by high velocity gas-flame process (HVOF). The present paper presents comparative study results for mechanical and tribological characteristics of galvanic Cr coatings without nanoparticles, galvanic Cr coatings modified by diamond nanoparticles NDDS of various concentration 0.6; 10; 15 и 20% obtained under three technological regimes, and composite WC-12Co coating. Comparative results about hardness, wear, wear resistance and friction coefficient are obtained for galvanic Cr-NDDS and WC-12Co coatings operating at equal friction conditions of dry friction on abrasive surface. The WC-12Co coating shows 5.4 to 7 times higher wear resistance compared to the galvanic Cr-NDDS coatings.
- 30 April 2016
- Published by Springer Nature
- p. 219-240
Innovative Graphical Braille Screen for Visually Impaired People
- 30 April 2016
- Published by Springer Nature
- p. 219-240
Innovative Graphical Braille Screen for Visually Impaired People
- 1 March 2016
- Published by Allerton Press in Journal of Friction and Wear
- Vol. 37 (2) , 187-190
The influence of the valena metal-plating additive on tribotechnical characteristics of the Steel–Bronze tribological system
- 1 March 2016
- Published by Allerton Press in Journal of Friction and Wear
- Vol. 37 (2) , 187-190
The influence of the valena metal-plating additive on tribotechnical characteristics of the Steel–Bronze tribological system
- 26 November 2015
- Published by Springer Nature
- p. 69-79
Application of Fuzzy Topsis and Ahp Method in Evaluating Vehicle Roadworthiness Performance
- 26 November 2015
- Published by Springer Nature
- p. 69-79
Application of Fuzzy Topsis and Ahp Method in Evaluating Vehicle Roadworthiness Performance