Study on the impact of near-wall air systems' wind speed variations on the combustion characteristics in coal-fired boilers
Authors:
Open Access
- 1 January 2026
- journal article
- Published by National Library of Serbia in Thermal Science
- Vol. 30 (00) , 21
Abstract
With increasingly strict national energy policies mandating ultra-low emissions for coal-fired power plants, the issue of high-temperature corrosion caused by reductive gases and elevated furnace temperatures has become critical. This study proposes the implementation of near-wall air systems on both sides of mid-furnace burners to mitigate water-cooled wall corrosion and enhance combustion efficiency. Using numerical simulation, the effects of a near-wall air system with a wind speed of 20 m/s were analyzed across the entire furnace. Results show that this approach reduces the average near-wall temperature by 4%, while increasing O? concentration in the combustion zone by approximately 6%, thus promoting more efficient combustion. Additionally, CO? and CO concentrations decrease by about 4.5% and 5.9%, respectively, effectively reducing reductive gases and alleviating high-temperature corrosion. NOx decreased significantly by 18.7%, indicating that air classification effectively suppressed NOx, which is a sign of efficient and low-nitrogen combustion. These findings offer a practical solution for improving boiler operational safety and efficiency under ultra-low emission requirements.Keywords
This publication has 29 references indexed in Scilit:
- Optimization study of low-NO combustion in boiler based on pulverized coal preheating solutionCase Studies in Thermal Engineering, 2024
- Numerical investigation of stable combustion at ultra-low load for a 350 MW wall tangentially fired pulverized-coal boiler: Effect of burner adjustments and methane co-firingApplied Thermal Engineering, 2024
- Simulation research on thermal management system of battery module with fin heat dissipation structureApplied Thermal Engineering, 2023
- Combustion stability and NO emission characteristics of three combustion modes of pulverized coal boilers under low or ultra-low loadsApplied Energy, 2023
- Numerical simulation of combustion characteristics in a 660 MW tangentially fired pulverized coal boiler subjected to peak-load regulationCase Studies in Thermal Engineering, 2023
- Numerical study on the effects of primary air ratio on ultra-low-load combustion characteristics of a 1050 MW coal-fired boiler considering high-temperature corrosionApplied Thermal Engineering, 2022
- A novel burner arrangement scheme with annularly combined multiple airflows for wall-tangentially fired pulverized coal boilerEnergy, 2021
- Design of porous wall air coupling with air staged furnace for preventing high temperature corrosion and reducing NOx emissionsApplied Thermal Engineering, 2017
- Computational fluid dynamic simulation of oxyfuel combustion in gas-fired water tube boilersComputers & Fluids, 2012
- Numerical modelling and simulation of pulverized solid‐fuel combustion in swirl burnersThe Canadian Journal of Chemical Engineering, 2009