Numerical simulation of material flow in AA7075 during constrained friction processing
Open Access
- 11 February 2026
- journal article
- research article
- Published by Springer Nature in International Journal of Material Forming
- Vol. 19 (1) , 15
Abstract
Lightweight aluminum alloys, such as AA7075, are desirable for applications in various industries, but their limited formability and workability often pose significant challenges. Constrained Friction Processing (CFP) has emerged as a promising technique to address these challenges by refining microstructures through the relative motion between two tools and the workpiece. The process involves axial extrusion, dual tool rotation, and constraint of the extrudate to control material flow and enhance microstructural refinement. CFP is particularly attractive for high-strength AA7075 as it imposes constrained material flow and increased shear deformation, overcoming the limited formability observed in existing conventional extrusion processes. This study investigates CFP using both experimental and numerical methods, establishing correlations between process conditions, material flow, microstructural evolution, and hardness for the aluminum alloy AA7075. The process was investigated at rotational speeds of 1000–1400 rpm, resulting in the highest measured peak temperature up to 445°C and refined grain sizes of 2–3 µm. The results show that initial shear deformation and material flow under the rotating tools are redistributed during processing, leading to helical flow behavior in the extruded rod. The refined stir zone (SZ) exhibited increase in hardness, about 25% compared to the base material. The developed finite-element model demonstrates good agreement with experimental results with respect to the complete thermal cycle, spatial temperature distribution, and material flow patterns, providing insight into the microstructural evolution during CFP of aluminium alloys.Keywords
Funding Information
- Helmholtz-Zentrum hereon GmbH
This publication has 35 references indexed in Scilit:
- Effect of thermo-mechanical conditions during constrained friction processing on the particle refinement of AM50 Mg-alloy phasesJournal of Magnesium and Alloys, 2024
- Application of novel constrained friction processing method to produce fine grained biomedical Mg-Zn-Ca alloyJournal of Magnesium and Alloys, 2024
- Improving mechanical anisotropy and corrosion resistance of extruded AA7075 alloy by warm cross rolling and annealingJournal of Alloys and Compounds, 2021
- Modelling continuous dynamic recrystallization of aluminum alloys based on the polycrystal plasticity approachInternational Journal of Plasticity, 2020
- Thermo-mechanical Analysis of Friction Stir Welding: A Review on Recent AdvancesActa Metallurgica Sinica (English Letters), 2019
- Experimental and DFT characterization of η′ nano-phase and its interfaces in Al Zn Mg Cu alloysActa Materialia, 2019
- Thermomechanical Simulation of Friction Stir Welding Process Using Lagrangian Method2018
- Joining of automotive sheet materials by friction-based welding methods: A reviewEngineering Science and Technology, an International Journal, 2018
- Investigation of material flow during friction extrusion processInternational Journal of Mechanical Sciences, 2014
- First principles investigation of zinc-induced embrittlement in an aluminum grain boundaryActa Materialia, 2011