Feasibility Study on 3D-Printed Phase Change Material Containers Embedded in Mortar Slabs for Thermal Regulation

Authors:

Abstract
Integrating phase-change materials (PCMs) into building envelopes presents a promising pathway for passive thermal regulation and energy efficiency in the built environment. This study evaluates the feasibility of embedding paraffin-based PCM (RT27) within cementitious systems using 3D-printed polylactic acid (PLA) containers to enhance the thermal performance of mortar slab systems. Cylindrical containers (20 mm diameter) were fabricated using PLA and embedded into mortar slabs (300 mm × 300 mm × 50 mm) at a 15% volume fraction. Control specimens without PCM were also prepared for comparative analysis. A custom-built experimental setup, comprising a hot-box chamber and a vertical exposure assembly, was developed to simulate solar radiation and monitor heat transfer behaviour under controlled laboratory conditions. Thermal testing verified that PCM-integrated mortar slabs reduced peak external surface temperatures by approximately 1.5-1.8 °C compared with reference slabs under both open and hot-box experimental conditions. In addition, the PCM specimens exhibited a thermal delay of approximately 20-30 minutes, indicating slower heat propagation through the material. This behaviour is attributed to the latent heat storage capacity of RT27 (approximately 160-164 kJ kg −1 during phase transition) enhancing the effective thermal inertia of the mortar system within the PCM melting temperature range (27-29 °C). Additionally, ultrasonic pulse velocity (UPV) measurements confirmed that the integration of PCM containers did not compromise structural integrity. These results establish a scalable and fabrication-compatible strategy for improving the thermal inertia of cement-based construction materials, offering significant potential for energy-efficient and climate-responsive building applications.

This publication has 13 references indexed in Scilit: