Optimization and modeling of Pb 2+ ions adsorption on bentonite and HNO 3 -activated bentonite using Taguchi and ANOVA methods
Open Access
- 1 February 2025
- journal article
- Published by SAGE Publications in Adsorption Science & Technology
- Vol. 43
Abstract
This study investigates the activation of bentonite using HNO 3 and its application for Pb 2+ adsorption. Physical-chemical analyses (Brunauer–Emmett–Teller, X-ray diffraction, and Fourier transform infrared) revealed that HNO 3 activation enhanced the surface area and altered the structural characteristics of bentonite. Adsorption experiments, designed using the Taguchi method (L25, four factors, five levels), identified contact time as the most influential factor for Pb 2+ removal. The maximum Pb 2+ adsorption capacity of HNO 3 -activated bentonite was 1.3 times higher than raw bentonite (61.77 mg/g vs 48.22 mg/g). Adsorption isotherms fitted well with the Temkin model (R 2 > 0.9, χ 2 < 0.15), and kinetic data followed the Elovich model (R 2 > 0.91, χ 2 < 1.44). The initial sorption rate (α) for HNO 3 -activated bentonite was 1.12 times greater than that of bentonite, indicating enhanced adsorption kinetics. This study demonstrates the effectiveness of HNO 3 -activated bentonite for efficient Pb 2+ removal from aqueous solutions.Keywords
This publication has 73 references indexed in Scilit:
- A state-of-the-art review on wastewater treatment techniques: the effectiveness of adsorption methodEnvironmental Science and Pollution Research, 2021
- The use of bentonite and organic amendments for remediation of Cd contaminated fields: An environmental perspectiveLand Degradation & Development, 2020
- Clay mineral adsorbents for heavy metal removal from wastewater: a reviewEnvironmental Chemistry Letters, 2018
- Kinetic and isotherms studies of phosphorus adsorption onto natural riparian wetland sediments: linear and non-linear methodsEnvironmental Monitoring and Assessment, 2015
- Adsorption of Cd(II), Cu(II), Ni(II) and Pb(II) onto natural bentonite: study in mono- and multi-metal systemsEnvironmental Earth Sciences, 2014
- Adsorption of Pb(II) on mesoporous activated carbons fabricated from water hyacinth using H3PO4 activation: Adsorption capacity, kinetic and isotherm studiesApplied Surface Science, 2014
- Adsorption of copper and zinc onto natural clay in single and binary systemsInternational Journal of Environmental Science and Technology, 2013
- Effect of catalyst synthesis parameters on the metal particle sizeApplied Catalysis A: General, 2013
- Effect of contact time, pH, and ionic strength on Cd(II) adsorption from aqueous solution onto bentonite from Gaomiaozi, ChinaEnvironmental Earth Sciences, 2010
- Alteration of smectites by treatments with hydrochloric acid and sodium carbonate solutionsApplied Clay Science, 1990