High Quality P-Type 4H-SiC Growth by PVT Method
Open Access
- 18 May 2026
- journal article
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 452, 59-64
Abstract
The fabrication of n-channel IGBTs is constrained by the low conductivity as well as poor quality of the p-type SiC substrate. This paper reports 6-inch high quality p-type 4H-SiC wafers achieved by PVT method. The wafers were examined by synchrotron X-ray topography indicating average defect densities are on par or better than commercial 6-inch n-type wafers. Large areas of the wafer, especially the middle region of the wafer is characterized by very low density of BPDs. The extent of prismatic slip due to radial thermal gradients is also vastly reduced compared to typical n-type wafers.Keywords
This publication has 7 references indexed in Scilit:
- Wafer-Scale p-Type SiC Single Crystals with High Crystalline QualityCrystal Growth & Design, 2024
- A Review of SiC IGBT: Models, Fabrications, Characteristics, and ApplicationsIEEE Transactions on Power Electronics, 2020
- Crystal growth and evaluation of nitrogen and aluminum co-doped N-type 4H-SiC grown by physical vapor transportJournal of Crystal Growth, 2018
- Prismatic Slip in PVT-Grown 4H-SiC CrystalsJournal of Electronic Materials, 2016
- (Invited) Study on the Role of Thermal Stress on Prismatic Slip of Dislocations in 4H-SiC Crystals Grown by PVT MethodECS Transactions, 2016
- Quantitative Comparison Between Dislocation Densities in Offcut 4H-SiC Wafers Measured Using Synchrotron X-ray Topography and Molten KOH EtchingJournal of Electronic Materials, 2013
- X-Ray Topography Techniques for Defect Characterization of Crystals2010