Investigation of the Effect of Molding Variables on Sink Marks of Plastic Injection Molded Parts Using Taguchi DOE Technique
Authors:
- 8 March 2007
- journal article
- research article
- Published by Taylor & Francis in Polymer-Plastics Technology and Engineering
- Vol. 46 (3) , 219-225
Abstract
The quality of an injection molded part is affected by material properties, mold geometry, process conditions etc. Obtaining optimum process conditions and mold design is the key problem to improve the part quality. Sink mark is one of several important flaws of injection molded parts. In this article, numerical simulation is combined with Taguchi design-of-experiment (DOE) technique to investigate the influence of process conditions and cavity geometry on sink mark of the injection molded part and optimize process conditions and cavity geometry. An L18(37) orthogonal array based on the Taguchi method was conducted to minimize the sink marks of injection molded parts, and the significance of each factors on sink mark was investigated. For the factors selected in the main experiments, part thickness, holding pressure, melt temperature and mold temperature were found to be the principal factors affecting the sink marks of the injection molded parts.Keywords
This publication has 6 references indexed in Scilit:
- Shrinkage behavior and optimization of injection molded parts studied by the taguchi methodPolymer Engineering & Science, 2001
- Effects of processing parameters on formation of sinkmarks on injection moulded partsPlastics, Rubber and Composites: Macromolecular Engineering, 2001
- Application of the Taguchi Method to Optimize the Surface Quality of Gas Assist Injection Molded CompositesJournal of Reinforced Plastics and Composites, 2000
- Optimization of Process Parameters of Injection Molding with Neural Network Application in a Process Simulation EnvironmentCIRP Annals, 1994
- A unified simulation of the filling and postfilling stages in injection molding. Part I: FormulationPolymer Engineering & Science, 1991
- Knowledge-based synthesis system for injection moldingRobotics and Computer-Integrated Manufacturing, 1987