Experimental Evaluation of Thermal Performance in Shell and Tube Heat Exchangers Using Al₂O₃-γ Nanofluids
Open Access
- 24 September 2024
- conference paper
- Published by MDPI AG in Engineering Proceedings
- Vol. 75 (1) , 13
Abstract
Shell and tube heat exchangers (H.Xs) are being used broadly in the generation of power, refrigeration, nuclear, chemical, and petroleum industries due to their high cooling and heating capacity. In this research paper, an experimental test bench for a shell and tube H.X was fabricated according to the standard. This study aimed to test the thermal performance of shell and tube H.Xs using Al2O3-γ nanofluid with different concentrations in counter flow configurations. Nanoparticles of 12 nm of size and 99% purity were used in this investigation. These nanoparticles were dispersed in distilled water to prepare nanofluids at three different concentrations: 0.11%, 0.22%, and 0.34%. Nanofluids of different concentrations were heated and passed through H.X tubes while water was passed through the shell side. The experiments were performed at three different flow rates: 6, 8, and 10 L per minute (L/min). It was observed from the experimentation that nanofluid has higher efficiency as compared to simple distilled water. Experimental investigations showed higher values of overall heat transfer coefficient (U), convective heat transfer coefficient (h), and heat transfer rate () at 0.22%, noted as 33.33%, 48%, and 30%, respectively. The lowest value for U was noted 47% for distilled water. The hydrodynamic and thermal boundary layers were also determined, and when the flow rate increased it led to thinning of the thermal boundary layer and improved heat transfer; however, increased concentrations of nanoparticles thickened the boundary layer by increasing viscosity and boosting thermal conductivity (k) simultaneously. It was revealed that the best concentration for maximizing heat transfer was 0.22%. The findings show that heat transmission efficiency was improved at both 0.11% and 0.22% of nanofluids compared to simple distilled water; when the concentration was raised to 0.34%, the results decreased due to increasing viscosity. Therefore, there is a need to precisely adjust the nanoparticle loading rate for maximum heat transfer enhancement without affecting fluid properties.
Keywords
This publication has 15 references indexed in Scilit:
- What dominates heat transfer performance of hybrid nanofluid in single pass shell and tube heat exchanger?Advanced Powder Technology, 2019
- Experimental analyses on heat transfer performance of TiO2–water nanofluid in double-pipe counter-flow heat exchanger for various flow regimesJournal of Thermal Analysis and Calorimetry, 2019
- Thermal performance augmentation using water based Al2O3-gamma nanofluid in a horizontal shell and tube heat exchanger under forced circulationInternational Communications in Heat and Mass Transfer, 2017
- Experimental investigation on Al2O3–W, SiO2–W and ZnO–W nanofluids and their application in a shell and tube heat exchangerInternational Journal of Heat and Mass Transfer, 2016
- Extended Maxwell model for the thermal conductivity of nanofluids that accounts for nonlocal heat transferInternational Journal of Thermal Sciences, 2014
- An experimental investigation of heat transfer enhancement of a minichannel heat sink using Al2O3–H2O nanofluidInternational Journal of Heat and Mass Transfer, 2014
- Heat transfer characteristics of silver/water nanofluids in a shell and tube heat exchangerArchives of Civil and Mechanical Engineering, 2014
- Boundary layer analysis and heat transfer of a nanofluidMicrofluidics and Nanofluidics, 2014
- Heat transfer of nanofluids in a shell and tube heat exchangerInternational Journal of Heat and Mass Transfer, 2010
- Enhancement of Thermal Conductivity with CuO for NanofluidsChemical Engineering & Technology, 2006