Microstructure and Tensile Properties Anisotropy of 7xxx Ultra-Thick Plate
- 22 June 2021
- journal article
- research article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1035, 134-142
Abstract
The microstructure,texture distribution and tensile property of 7xxx ultra-thick plate was investigated by optical microscopy (OM), scanning electron microscopy (SEM), electron back scattering diffraction (EBSD), transmission electron microscopy (TEM) and tensile tests. The results show that the microstructure, texture and tensile property were inhomogeneous along the thickness direction. A large number of sub-crystals remained on the surface of the thick plate and was accompanied by much recrystallization. Most of the structures were random texture, and the proportion of typical texture was low at the edge. For the center layer, there were also a lot of recrystallized grains and typical deformed texture along the β-fiber (Brass, S, and Copper) was observed. The 1/4 layer of the plate is a transition one, and had the lowest recrystallized fraction. From surface to center, precipitation phases within grains and grain boundaries gradually coarsen, mechanical properties reduced. At the same thickness, the tensile property showed appreciable anisotropy, the L direction was the highest and the S direction was the lowest.Keywords
This publication has 19 references indexed in Scilit:
- Effect of plate thickness on the environmental fatigue crack growth behavior of AA7085-T7451International Journal of Fatigue, 2016
- Effects of Al3(Sc,Zr) and Shear Band Formation on the Tensile Properties and Fracture Behavior of Al-Mg-Sc-Zr AlloyJournal of Materials Engineering and Performance, 2015
- Effect of Yb additions on microstructures and properties of 7A60 aluminum alloyTransactions of Nonferrous Metals Society of China, 2008
- Plastic anisotropy in AA5005 Al?1Mg: predictions using crystal plasticity finite element analysisScripta Materialia, 2004
- Modelling of microstructure evolution during hot rolling of AA5083 using an internal state variable approach integrated into an FE modelMaterials Science and Engineering: A, 2004
- A model for the yield strength of overaged Al–Zn–Mg–Cu alloysActa Materialia, 2003
- Influence of forming parameters on static recrystallization behaviour during hot rolling aluminium alloy 5083Modelling and Simulation in Materials Science and Engineering, 2002
- Quench sensitivity and tensile property inhomogeneity in 7010 forgingsJournal of Materials Processing Technology, 2001
- Macroscopic anisotropy in AA5019A sheetsActa Materialia, 2000
- Microstructural modelling of aluminium alloys during thermomechanical processingMaterials Science and Engineering: A, 2000