EFFECT OF SURFACTANT ON SATURATED POOL BOILING OVER POROUS COATED SURFACE
- 1 January 2023
- journal article
- research article
- Published by Begell House Inc. Publishers in Journal of Enhanced Heat Transfer
- Vol. 30 (1) , 1-14
Abstract
The present study reports the investigation on heat transfer enhancement due to the combined effect of coating on heater surface and addition of surfactant to test liquid during saturated pool boiling. It is achieved by TiO2 coating on aluminum heater surface combined with addition of surfactant sodium lauryl sulphate (SLS) to different base liquids such as acetone, ethanol, and isopropanol. The experiments were conducted under saturated condition and varying the surfactant concentration between 200 and 1000 ppm. The heat flux is varied within the range 13-65 kW/m2. The pool boiling heat transfer coefficients and surface superheats are determined and analyzed. The pool boiling heat transfer coefficients are found to be increasing with addition of surfactant up to 400 ppm, which is the critical micelle concentration (CMC), and deteriorates beyond the 400 ppm. The enhancement factors are determined, which are the ratios between the pool boiling heat transfer coefficients over coated surface to that of plain surface. Finally, it is realized that the enhancement factors are higher for the lower surfactant concentration irrespective of the base fluid. It decreases as the heat flux increases for a particular surfactant concentration. It is found to be higher for pure liquid and with concentrations of surfactant below 400 ppm. For higher concentrations of surfactant, the enhancement factors are not so significant. However, its value lies in the range of 1.5 to 3 for all combinations of surfactant and base fluid.Keywords
This publication has 21 references indexed in Scilit:
- Enhancement of pool boiling heat transfer using innovative non-ionic surfactant on a wire heaterExperimental Thermal and Fluid Science, 2017
- Enhancement of Pool Boiling Heat Transfer in Water Using Sintered Copper Microporous CoatingsNuclear Engineering and Technology, 2016
- Effect of structural parameters on pool boiling heat transfer for porous interconnected microchannel netsInternational Journal of Heat and Mass Transfer, 2016
- Pool boiling enhancement through microporous coatings selectively electrodeposited on fin tops of open microchannelsInternational Journal of Heat and Mass Transfer, 2014
- Influence of heated surfaces and fluids on pool boiling heat transferExperimental Thermal and Fluid Science, 2014
- Pool boiling enhancement with environmentally friendly surfactant additivesJournal of Thermal Analysis and Calorimetry, 2014
- Enhancement of pool boiling critical heat flux in dielectric liquids by microporous coatingsInternational Journal of Heat and Mass Transfer, 2007
- The effect of surfactants on bubble growth, wall thermal patterns and heat transfer in pool boilingInternational Journal of Heat and Mass Transfer, 2001
- Effects of heater size and orientation on pool boiling heat transfer from microporous coated surfacesInternational Journal of Heat and Mass Transfer, 2001
- Pool Boiling Heat Transfer in Aqueous Solutions of an Anionic SurfactantJournal of Heat Transfer, 2000