Electrochemical Reduction of CO2: Effect of Convective CO2 Supply in Gas Diffusion Electrodes
- 18 November 2019
- journal article
- research article
- Published by Wiley in ChemElectroChem
- Vol. 6 (22) , 5596-5602
Abstract
The electrochemical reduction of carbon dioxide (CO2) is a promising technology in light of energy transition and industrial electrification. In this study, two different electrolyzer configurations, flow‐through and flow‐by modes, were analyzed for the production of carbon monoxide to resolve the CO2 mass‐transfer limitation problem at high current densities in gas diffusion electrodes. These two configurations respectively state convective and diffusive flow inside the gas diffusion layer, and their effect was studied on the cathodic performance of the electrolyzer by varying the operating conditions: cathodic potential, electrocatalyst loading, and Nafion content. In flow‐through configuration, a current density of 220 mA/cm2 could be achieved at a faradaic efficiency of 90 %; whereas, in the flow‐by configuration, the current density was at the same faradaic efficiency limited to 140 mA/cm2. However, the flow‐through configuration has a few limitations, such as lower energy efficiency, owing to the higher ohmic drop and the faster deactivation caused by crystallization of electrolyte salts inside the gas diffusion electrode. Therefore, flow‐by mode is currently the most adequate configuration for the long‐term operation of electrolyzers for the reduction of CO2 to CO. This study represents an essential step toward the application of electrolyzers for the electroreduction of CO2.Keywords
This publication has 31 references indexed in Scilit:
- Influence of dilute feed and pH on electrochemical reduction of CO2 to CO on Ag in a continuous flow electrolyzerElectrochimica Acta, 2015
- Enhanced performance of gas diffusion electrode for electrochemical reduction of carbon dioxide to formate by adding polytetrafluoroethylene into catalyst layerJournal of Power Sources, 2015
- Electrochemical reduction of carbon dioxide: IV dependence of the Faradaic efficiency and current density on the microstructure and thickness of tin electrodeJournal of Power Sources, 2014
- Silver Supported on Titania as an Active Catalyst for Electrochemical Carbon Dioxide ReductionChemSusChem, 2014
- New insights into the electrochemical reduction of carbon dioxide on metallic copper surfacesEnergy & Environmental Science, 2012
- Bench-scale electrochemical system for generation of CO and syn-gasJournal of Applied Electrochemistry, 2011
- Design of an Electrochemical Cell Making Syngas (CO+H[sub 2]) from CO[sub 2] and H[sub 2]O Reduction at Room TemperatureJournal of the Electrochemical Society, 2008
- An evaluation of electrocatalytic activity and stability for air electrodesJournal of Power Sources, 2004
- Nafion content in the catalyst layer of polymer electrolyte fuel cells: effects on structure and performanceElectrochimica Acta, 2001
- High Rate Gas Phase CO 2 Reduction to Ethylene and Methane Using Gas Diffusion ElectrodesJournal of the Electrochemical Society, 1990