Local Induction Melting Combined with Ultrasonic Melt Treatment: A Pilot Study on Porosity, Mechanical Properties, and Energy Efficiency in AlSi12 Castings
Open Access
Abstract
Light metal foundries consume large amounts of energy and rely mainly on gas-fired melting, which is inefficient and promotes porosity caused by dissolved hydrogen. This pilot study examines local induction melting combined with ultrasonic melt treatment (UST) as a decentralized and electrified alternative. AlSi12 was cast with varied mold temperature, casting temperature, UST duration and remelted fraction. Porosity was characterized by optical microscopy in 2D and, for a subset of specimens, by X-ray computed tomography in 3D, and the mechanical behavior by tensile testing. An experimentally benchmarked simulation was used to estimate the energy demand for larger batch sizes. Including the energy required for cooling, the measured laboratory efficiency was 7.9% to 14.9%, and the simulation predicts 41.3% for 100 kg, or 48% with a preheated crucible, against 53.1% derived for industrial induction furnaces. Specimens treated with UST showed a lower mean porosity, 0.56% against 2.14% in optical microscopy and 0.153% against 0.367% in computed tomography, where the pore count was 73% lower at almost unchanged pore size. Their mean strain at fracture was 45.5% higher and their mean toughness 53.2% higher, whereas the 4.4% higher mean tensile strength lies within the scatter of the measurements.Keywords
Funding Information
- Bavarian State Authority
This publication has 23 references indexed in Scilit:
- Energieeffizienz-Benchmark Industrie2025
- Multiphysics modeling and experimental validation of heat and mass transfer for the vacuum induction melting processApplied Thermal Engineering, 2024
- Ultrasonic Melt Treatment of Light AlloysInternational Journal of Metalcasting, 2018
- Numerical and Experimental Modeling of the Recirculating Melt Flow Inside an Induction Crucible FurnaceMetallurgical and Materials Transactions B, 2018
- Coupled electromagnetic and thermal analysis of induction heating for the forging of marine crankshaftsApplied Thermal Engineering, 2016
- Current State of Aluminum Melting and Holding Furnaces in IndustryJOM, 2015
- Experimental and Numerical Analysis of the Deformation of a Liquid Aluminum Free Surface Covered by an Oxide Layer During Induction MeltingMetallurgical and Materials Transactions B, 2015
- Melting2015
- Numerical Modeling of Free Surface Dynamics of Melt in an Alternate Electromagnetic Field: Part I. Implementation and Verification of ModelMetallurgical and Materials Transactions B, 2013
- Influence of ultrasonic melt treatment on microstructure and mechanical properties of AlSi9Cu3 alloyJournal of Materials Processing Technology, 2011