Overall Buckling Behavior and Design of Steel Stiffened Box Section Columns Under Axial Compression
Open Access
Abstract
This study experimentally and numerically investigated the overall buckling behavior of steel box column components. Two box section specimens were fabricated for axial compression tests. Prior to the tests, the material properties, initial geometric imperfections and residual stress were measured. In addition, an extended parameter analysis was conducted using a finite element model validated by experimental results to evaluate the impact of geometric defects and residual stresses on the bearing capacity of unstiffened and stiffened box section columns. A novel column curve was proposed based on massive datasets of parametric models. The short and long column specimens exhibited typical strength failure and buckling failure modes, respectively. The initial geometric imperfections and residual stresses slightly reduced the buckling strength from the models, with a maximum reduction in buckling strength owing to initial geometric imperfections of 5.2% and that owing to residual stresses of 6.52%. The unstiffened and stiffened box columns have the same stability coefficient when the slenderness ratio is the same. Additionally, the ultimate load capacity calculation formula for stiffened box columns proposed in this paper averages 2.20% higher than Class C curves in JTG D64-2015, lies between Japanese and U.S. codes, and demonstrates good accuracy.Keywords
Funding Information
- Guangdong Provincial Department of Housing and Urban-Rural (2023-K19-424337)
This publication has 24 references indexed in Scilit:
- Comprehensive exploration of technological tensioning effects in welded thin plate girders: an in-depth investigationJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2024
- Experimental and numerical study of residual stresses in 550 MPa high strength steel welded angle sectionsStructures, 2023
- Equivalent geometrical imperfections for local and global interaction buckling of welded square box section columnsStructures, 2023
- Eigenvalue analysis of flexural-torsional buckling of angle-bar stiffened platesInternational Journal of Steel Structures, 2016
- Effective breadth/web concept for elastic coupled buckling analysis in flat-bar stiffened platesEngineering Structures, 2014
- Overall buckling behavior of 460MPa high strength steel columns: Experimental investigation and design methodJournal of Constructional Steel Research, 2012
- Tests and numerical study of ultra-high strength steel columns with end restraintsJournal of Constructional Steel Research, 2012
- Reliability assessment of post-buckling compressive strength of laminated composite plates and stiffened panels under axial compressionInternational Journal of Solids and Structures, 2007
- Applicability of low-yield-strength steel for ductility improvement of steel bridge piersEngineering Structures, 2005
- Parametric studies on cable-stayed bridgesComputers & Structures, 1996